Hardware

tmf8829-adapter-molecule

tmf8829-adapter-molecule·Adom

TMF8829 breakout onto a 32 x 32 mm machine-pin datum

ranger-micro-breakout-molecule-extended

ranger-micro-breakout-molecule-extended·Adom

U.FL + SMP + YAT attenuator breakout — 104 x 104 mm

rp1-breakout-molecule-extended

rp1-breakout-molecule-extended·Adom

U.FL + SMP + YAT attenuator on a machine-pin breakout — 104 x 104 mm

combiner-molecule

combiner-molecule·Adom

Two Mini-Circuits EP2W+ combiners, four SMP jacks — 104 x 104 mm

coax-antennuator-molecule-32x32

coax-antennuator-molecule-32x32·Adom

Inline Mini-Circuits YAT attenuator between two SMP jacks

coax-molecule-2ch-64x64

coax-molecule-2ch-64x64·Adom

Four Amphenol SMP jacks — two coax channels — 64 x 64 mm

coax-molecule-32x32

coax-molecule-32x32·Adom

Two Amphenol SMP jacks on a 32 x 32 mm datum

rf-mech-molecule-64x64

rf-mech-molecule-64x64·Adom

Mechanical datum — machine pins + mounting holes — 64 x 64 mm

rf-mech-molecule-32x64

rf-mech-molecule-32x64·Adom

Mechanical datum — machine pins + mounting holes — 32 x 64 mm

rf-mech-molecule-32x32

rf-mech-molecule-32x32·Adom

Mechanical datum — machine pins + mounting holes — 32 x 32 mm

Drone Motor Carrier

drone-motor-carrier·Adom·PCBA 104 x 104 mm, 4-layer

Passive baseplate for the single-motor drone test cell: mounts the BLDC motor, passes its three phases through, routes two load-cell channels, and nests the RP2350A/ADS1220 acquisition molecule and a PiProbe over a 96 x 96 mm machine-pin datum. 104 x 104 mm, 4-layer.

FC Carrier (RP2350A-Mini)

carrier-fc-rp2350a-mini·Adom·PCBA 38.8 x 70.8 mm, 4-layer

Flight-controller carrier for the single-motor drone cell: hosts the RP2350A-Mini, bridges 5 V to two loads, monitors the 5 V rail into the mini's ADC, and carries a hardware E-stop that drives the ESC brake. 38.8 x 70.8 mm, 4-layer, 32 x 64 mm datum.

RP2350A + ADS1220 Molecule

rp2350a-ads1220·Adom·PCBA 26.4 x 36.0 mm, 4-layer

24-bit thrust-acquisition molecule for the drone motor carrier: an RP2350A paired with a TI ADS1220 24-bit ADC, W25Q16JV flash and AP2112K-3.3 LDO, with a ratiometric load-cell front-end. Nests on the motor carrier over machine pins.

ESC G431

esc-g431·Adom·PCBA 64 x 74 mm, 4-layer

Single-motor ESC for the drone test cell: STM32G431 + DRV8300 driving a 3-phase bridge of six BSC016N06NS MOSFETs, TPSM365 buck to 12 V, INA181 low-side current sense (25 mV/A, 131 A full-scale). Runs AM32. 64 x 74 mm, 4-layer.

rf-scaffold-module

rf-scaffold-module·Adom

SMP to SMPM edge, on a machine-pin datum — 32 x 88 mm

rf-workcell-module

rf-workcell-module·Adom

SMPM blind-mate to SMA end-launch — 41 x 64 mm

tmf8829-molecule

tmf8829-molecule·Adom

ams OSRAM TMF8829 direct time-of-flight sensor · 16 x 21 mm

RP2040 Breakout — KiCad Bridge Pipeline Demo

RP2040 Breakout Pipeline Demo·Adom

RP2040 breakout board pushed end-to-end through the Adom KiCad bridge molecule pipeline: kicad_export_molecule (STEP + ray-traced silkscreen renders on a GPU VM) -> step2glb color-preserving GLB -> adom-molecule. Annotated silks (U1/C1-C5/Y1/J1), USB-C, 12 MHz crystal, QFN-56 RP2040.

bmi270-molecule

BMI270·Bosch Sensortec

Bosch BMI270 6-axis IMU (3-axis accelerometer + 3-axis gyroscope) packaged as an Adom molecule — anchored GLB, machine-pin wings, KiCad source.

bme690-molecule

BME690·Bosch Sensortec

Bosch BME690 4-in-1 environmental sensor (gas, pressure, humidity, temperature) packaged as an Adom molecule — anchored GLB, machine-pin wings, KiCad source.

Teazzers Taprite Solenoid 638-0031 v1

Teazzers Taprite Solenoid 638-0031 v1

Electromechanical carrier molecule for the Taprite 638-0031 DC 24V solenoid valve — 198×102 mm, 6 machine contacts (2× GND, 2× VCC), 4 alignment machine pins. Designed for the Teazzers beverage dispen

rp2350a-mini

RP2350A_Mini·Adom·molecule-module

General-purpose RP2350A castellated module — 20×36 mm, dual-core Arm Cortex-M33 / Hazard3 RISC-V MCU with 16 Mbit QSPI flash, USB, UART, SWD debug, and 4 ADC channels. 26 user-programmable GPIO/ADC pins on castellated machine contacts (44 contacts + 4 corner machine pins). Drop-in MCU module for Adom workcell designs.

Teazzers - Taprite: Solenoid Multi-Carrier

Teazzers_Taprite_Solonoid-638-0031_Multicarrier_v1.0·Teazzers x Taprite·molecule-carrier

Teazzers_Taprite_Solonoid-638-0031_Multicarrier_v1.0 - Carrier board for (4) Taprite Solenoid (638-0031) breaking out [Power]. Includes red "power on" LEDs. Drive current = 0.7A/solenoid

Teazzers - Taprite: Solenoid Carrier

Teazzers_Taprite_Solonoid-638-0031_v2.0·Teazzers x Taprite·molecule-carrier

Teazzers_Taprite_Solonoid-638-0031_v2.0 - Carrier board for single Taprite Solenoid (638-0031) breaking out [Power]. Includes red "power on" LED. Solenoid drive current = 0.7A

taprite-solonoid-wiretest

Taprite Solonoid molecule (KiCad) wiring-pipeline test: anchored GLB + .kicad_pcb. Validates KiCad publish->import->footprint->wiring end to end.

I2S: Carrier

I2S_Carrier·Adom·molecule-carrier

I2S_Carrier_v1.0: Carrier for I2S MEMs Microphones, standardized to fit all MEMs varients. Jumper selects Left or Right.

bmv080-molecule

BMV080·Bosch Sensortec

Bosch BMV080 ultra-compact PM2.5 particulate-matter sensor packaged as an Adom molecule — anchored GLB, machine-pin wings, FPC connector, KiCad source.

piprobe-v1-3

PiProbe_v1.3·Adom·molecule-module

PiProbe_v1.3: RP2040-based SWD debug probe molecule — 28×20 mm, CMSIS-DAP with SWD debug + UART passthrough, 9 machine contacts + 4 machine pins. Runs Raspberry Pi Debugprobe firmware. Flash and debug

piprobe-occt-unified

PiProbe OCCT single-source bundle (GLB + footprint w/ per-pad Z + symbol).

piprobe-occt-molecule

PiProbe molecule — full OCCT molecule-mode output (auto-anchor FL->origin, gold PBR pins, join+Draco) from a KiCad-10 desktop STEP export. End-to-end pipeline validation artifact.

rp2350a-mini-wiretest

RP2350A Mini molecule (KiCad) wiring-pipeline test: anchored GLB + .kicad_pcb. Validates KiCad publish->import->footprint->wiring end to end.

piprobe-wiretest

PiProbe molecule (KiCad-origin) wiring-pipeline test: KiCad GLB + .kicad_pcb. Validates the KiCad publish -> import -> footprint -> wiring path end to end.

molecule-ap2114h-wiretest

AP2114H molecule (KiCad) wiring-pipeline test: anchored GLB + .kicad_pcb.

taprite-mosfet-wiretest

Taprite MOSFET molecule (KiCad) wiring-pipeline test: anchored GLB + .kicad_pcb. Validates KiCad publish->import->footprint->wiring end to end.

usb2532-hub-c-wiretest

USB2532 HUB molecule (KiCad) wiring-pipeline test: anchored GLB + .kicad_pcb. Validates KiCad publish->import->footprint->wiring end to end.