Generated by kicad-footprint-generator · KiCad file format 20260206
HV9912NG-G
Microchip Tech · LED Drivers · SOIC-16
HV9912NG-G from Microchip Tech, in a SOIC-16. Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.
Pinout
| Pin | Name | Type | Function |
|---|---|---|---|
| 1 | VIN | power_in | Input of the 90V high-voltage linear regulator that powers the IC. |
| 2 | VDD | power_out | Power supply pin for all internal circuits, regulated to 7.75V typical; must be bypassed with a low-ESR capacitor of at least 0.1 µF to GND. |
| 3 | GATE | output | Output gate driver (+0.2A/-0.4A) for an external N-channel power MOSFET. |
| 4 | GND | power_in | Ground return for all low-power analog internal circuitry; must be connected to the return path from the input. |
| 5 | CS | input | Senses the source current of the external power FET and includes a built-in 100 ns (minimum) blanking time. |
| 6 | SC | passive | Sets the slope compensation (current sourced out of the pin is 0 to 100 µA). |
| 7 | RT | passive | Sets the frequency of the power circuit; a resistor between RT and GND programs Constant Frequency mode. |
| 8 | SYNC | bidirectional | I/O pin that may be connected to the SYNC pin of other HV9912 ICs, causing the oscillators to lock to the highest frequency oscillator. |
| 9 | CLIM | input | Programmable input current limit for the converter, set using a resistor divider from the REF pin. |
| 10 | REF | power_out | 2% accurate reference voltage output; must be bypassed with a 0.01 µF-0.1 µF capacitor to GND. |
| 11 | FAULT | output | Pulled to ground on an output short-circuit or output overvoltage condition; can drive an external MOSFET to disconnect the load from the source. |
| 12 | OVP | input | Overvoltage protection input: GATE turns off and FAULT goes low when the voltage exceeds 5V, and the IC turns on again when it falls below 4.5V. |
| 13 | PWMD | input | PWM dimming input: switching is disabled when pulled to GND or left open, and resumes when an external TTL high level is applied. |
| 14 | COMP | passive | Connection for the closed-loop compensation network to GND; the capacitor also controls the hiccup time. |
| 15 | IREF | input | The voltage at this pin sets the output current level, set using a resistor divider from the REF pin. |
| 16 | FDBK | input | Provides output current feedback to the IC using a current sense resistor. |
Key specifications
| Parameter | Value |
|---|---|
| Manufacturer | Microchip Tech |
| Package | SOIC-16 |
| Category | Nixie Tube Driver/LED Driver |
| Pins | 16 |
Electrical characteristics
Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).
| Parameter | Symbol | Min | Typ | Max | Unit | Conditions | Page |
|---|---|---|---|---|---|---|---|
| Input DC Supply Voltage Range | VINDC | 90 | V | DC input voltage (Note 2) | 4 | ||
| Shutdown Mode Supply Current | IINSD | 1.5 | mA | PWMD connected to GND (Note 2) | 4 | ||
| Internally Regulated Voltage | VDD | 7.25 | 7.75 | 8.25 | V | VIN = 9V-90V; PWMD connected to GND (Note 2) | 4 |
| VDD Undervoltage Lockout Threshold | UVLORISE | 6.5 | 7 | V | VDD rising | 4 | |
| VDD Undervoltage Lockout Hysteresis | UVLOHYST | 500 | mV | VDD falling | 4 | ||
| REF Pin Voltage | VREF | 1.225 | 1.25 | 1.285 | V | REF bypassed with a 0.1 µF capacitor to GND; IREF = 0; PWMD = GND; 0°C < TA < +85°C | 4 |
| REF Pin Voltage (full temp) | VREF | 1.225 | 1.25 | 1.29 | V | REF bypassed with a 0.1 µF capacitor to GND; IREF = 0; PWMD = GND; -40°C < TA < 125°C | 4 |
| Line Regulation of Reference Voltage | VREFLINE | 0 | 20 | mV | REF bypassed with a 0.1 µF capacitor to GND; IREF = 0; VDD = 7.25V-12V; PWMD = GND | 4 | |
| Load Regulation of Reference Voltage | VREFLOAD | 0 | 10 | mV | REF bypassed with a 0.1 µF capacitor to GND; IREF = 0 µA-500 µA; PWMD = GND | 5 | |
| PWMD Input Low Voltage | VPWMD(LO) | 0.8 | V | Note 2 | 5 | ||
| PWMD Input High Voltage | VPWMD(HI) | 2 | V | Note 2 | 5 | ||
| PWMD Pull-down Resistance | RPWMD | 50 | 100 | 150 | kΩ | VPWMD = 5V | 5 |
| GATE Short-circuit Current | ISOURCE | 0.2 | A | VGATE = 0V | 5 | ||
| GATE Sinking Current | ISINK | 0.4 | A | VGATE = VDD | 5 | ||
| GATE Output Rise Time | TRISE | 50 | 85 | ns | CGATE = 1 nF | 5 | |
| GATE Output Fall Time | TFALL | 25 | 45 | ns | CGATE = 1 nF | 5 | |
| Overvoltage Rising Trip Point | VOVP,RISING | 4.75 | 5 | 5.25 | V | OVP rising | 5 |
| Overvoltage Hysteresis | VOVP,HYST | 0.5 | V | OVP falling | 5 | ||
| Leading Edge Blanking | TBLANK | 100 | 280 | ns | 0°C < TA < +85°C | 5 | |
| Leading Edge Blanking (full temp) | TBLANK | 100 | 330 | ns | -40°C < TA < +125°C | 5 | |
| Delay to Output of COMP Comparator | TDELAY1 | 200 | ns | COMP = VDD; CLIM = REF; CSENSE = 0 mV to 600 mV (step up) | 5 | ||
| Delay to Output of CLIMIT Comparator | TDELAY2 | 200 | ns | COMP = VDD; CLIM = 300 mV; CSENSE = 0 mV to 400 mV (step up) | 5 | ||
| Comparator Offset Voltage | VOFFSET | -10 | 10 | mV | 5 | ||
| Gain Bandwidth Product | GBW | 1 | MHz | 75 pF capacitance at OP pin (Note 3) | 5 | ||
| Open-loop DC Gain | AV | 60 | dB | Output open | 5 | ||
| Input Common Mode Range | VCM | -0.3 | 3 | V | Note 3 | 5 | |
| Output Voltage Range | VO | 0.7 | 6.75 | V | Note 3 | 5 | |
| Transconductance | gM | 450 | 550 | 650 | µA/V | 5 | |
| Input Offset Voltage | VOFFSET | -5 | 5 | mV | 5 | ||
| Input Bias Current | IBIAS | 0.5 | 1 | nA | Note 3 | 5 | |
| Oscillator Frequency | fOSC1 | 99 | 106 | 118 | kHz | RT = 500 kΩ (Note 2) | 5 |
| Oscillator Frequency | fOSC2 | 510 | 580 | 650 | kHz | RT = 96 kΩ (Note 2) | 5 |
| Maximum Duty Cycle | DMAX | 87 | 93 | % | 5 | ||
| SYNC Input High | VSYNCH | 2 | V | 6 | |||
| SYNC Input Low | VSYNCL | 0.8 | V | 6 | |||
| SYNC Output Current | IOUTSYNC | 18 | µA | 6 | |||
| Gain for Short-circuit Comparator | GSC | 1.9 | 2 | 2.1 | V | 6 | |
| Minimum Output Voltage of the Gain Stage | VOMIN | 0.125 | 0.25 | V | 0°C < TA < +85°C; IREF = GND | 6 | |
| Minimum Output Voltage of the Gain Stage (full temp) | VOMIN | 0.125 | 0.26 | V | -40°C < TA < +125°C; IREF = GND | 6 | |
| Propagation Time for Short-circuit Detection | TOFF | 250 | ns | PWMD = VDD; IREF = 400 mA; FDBK step from 0 mV to 900 mV; FAULT goes from high to low | 6 | ||
| Fault Output Rise Time | TRISE,FAULT | 300 | ns | 330 pF capacitor at FAULT pin | 6 | ||
| Fault Output Fall Time | TFALL,FAULT | 300 | ns | 330 pF capacitor at FAULT pin | 6 | ||
| Blanking Time | TBLANK,SC | 480 | 900 | ns | 6 | ||
| Current Source at COMP Pin used for Hiccup Mode Protection | IHICCUP | 5 | µA | 6 | |||
| Current Sourced Out of SC Pin | ISLOPE | 0 | 100 | µA | Note 2 | 6 | |
| Internal Current Mirror Ratio | GSLOPE | 1.8 | 2 | 2.26 | ISLOPE = 50 µA; RSC = 1 kΩ | 6 | |
| Operating Junction Temperature | TJ | -40 | 125 | °C | 6 | ||
| Storage Temperature | Ts | -65 | 150 | °C | 6 | ||
| Package Thermal Resistance 16-lead SOIC | θJA | 83 | °C/W | 16-lead SOIC | 6 | ||
| VIN to GND | VIN | -0.5 | 100 | V | 4 | ||
| VDD to GND | VDD | -0.3 | 13.5 | V | 4 | ||
| CS to GND | CS | -0.3 | V | max is VDD+0.3V | 4 | ||
| PWMD to GND | PWMD | -0.3 | V | max is VDD+0.3V | 4 | ||
| GATE to GND | GATE | -0.3 | V | max is VDD+0.3V | 4 | ||
| All Other Pins to GND | -0.3 | V | max is VDD+0.3V | 4 | |||
| Continuous Power Dissipation | 1200 | mW | TA = +25°C | 4 | |||
| Operating Junction Temperature Range | -40 | 125 | °C | 4 | |||
| Storage Temperature Range | -65 | 150 | °C | 4 |
CAD (KiCad official)
- Symbol:
HV9912NG-G - Footprint:
Package_SO:SOIC-16_3.9x9.9mm_P1.27mm - 3D model: SOIC-16 (KiCad packages3D, STEP)
- 3D model files:
hv9912ng-g-etched.step/hv9912ng-g-etched.glbcarry the MPN laser-etched on the die in a toggleableAdom.LaserEtchgroup (Fusion-ready);hv9912ng-g.step/hv9912ng-g.glbare the bare package body.
Provenance
Data extracted from the manufacturer datasheet, not a distributor listing:
- Datasheet: Microchip Tech datasheet (20 pp, sha256
95071e3a782fc328, retrieved 2026-10-23, tier: manufacturer) - Extractor: parts-factory
2.0.0/extract_pins 0.3, primaryclaude-sonnet-5-5(text), consensusclaude-sonnet-5-5(agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish. - CAD: KiCad official libraries (CC-BY-SA 4.0).