main
John Lauer Publish 1.0.0 707ea4a

Fabrication and assembly

Use a 1.6 mm two-layer FR-4 board with 1 oz copper on each face, green solder mask, white legend and lead-free HASL. The outline is 92 × 84 mm. Both faces have fitted parts, so upload the assembly files in the double-sided assembly lane.

Upload the bare-board Gerber and drill ZIP, JLCPCB assembly BOM and JLCPCB placement CSV. Check the supplier preview for top and bottom component orientation, particularly the Schottky diodes, QFNs and polarized capacitors. The full procurement BOM includes separately fitted parts.

Use filled and copper-capped 0.25 mm thermal vias within the exposed ground pads of U1, U2 and U3 to avoid solder loss through the barrels during reflow. Identify the exact under-pad holes using the accompanying via table and the provided KiCad source. The standard low-cost two-layer quote may omit via-in-pad filling. Confirm the filled-and-capped process with the fab for this exact two-layer order and verify it in the production-file preview before releasing the assembly. The plated TO-220 mounting hole and all solderable through-hole pads must stay open. JLCPCB via covering options · TI TPS7A47 thermal land and stencil notes

Fit the Pico module and its headers, the rear laser, the machine pins and contacts, the precision trimmers and the tab-down TO-220 by hand as shown in the bill of materials. Keep the TO-220 drain tab mechanically clamped to its plated PCB land and electrically isolated from the chassis.

Check the as-drilled machine-pin and machine-contact hole fit on the first panel before pressing hardware into the remaining boards. Use the printed service legends for field wiring and the KiCad assembly drawing to locate small passive references.

Support the Pico while mating a USB cable and strain-relieve the cable to the optical base during experiments. The scaffold pins carry the board and wiring. They are not a reaction point for USB insertion.