3D Model
Open in new tab ↗
Loads when you scroll to it. Unloads after 5 minutes in the background.
Symbol & Footprint
Schematic Symbol
Open full view ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
PCB Footprint
Open full view ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
Datasheet
Open in new tab ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
README
markdownSLM6550
SOLA-IC · Battery Management ICs · SOP-8
SLM6550 from SOLA-IC, in a SOP-8. Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.
Pinout
| Pin | Name | Type | Function |
|---|---|---|---|
| 1 | GND | power_in | Ground reference pin for the charger. |
| 2 | VCC | power_in | Positive input supply voltage that powers the internal circuit; the charger enters low power mode when VCC drops to within 30mV of the BAT pin voltage, dropping IBAT to less than 2μA. |
| 3 | NCHRG | output | Open-drain charge status output that is pulled low by an internal switch while the battery is charging and is high impedance otherwise. |
| 4 | NSTDBY | output | Open-drain charge terminated status output that is pulled low by an internal switch to indicate the end of battery charge and is high impedance otherwise. |
| 5 | TS | input | Chip enable and battery temperature sense input that suspends charging when the voltage is below 45% or above 80% of VIN, and grounding it disables the chip. |
| 6 | BAT | bidirectional | Battery connection pin that delivers charge current to the battery and regulates it to 4.35V. |
| 7 | VS | power_in | Charge current sense pin, connected through the program resistor RS to the LX pin to set the charge current. |
| 8 | LX | output | External inductor connecting pin for the synchronous buck switching node. |
Key specifications
| Parameter | Value |
|---|---|
| Manufacturer | SOLA-IC |
| Package | SOP-8 |
| Category | Power Supply Chip |
| Pins | 8 |
Electrical characteristics
Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).
| Parameter | Symbol | Min | Typ | Max | Unit | Conditions | Page |
|---|---|---|---|---|---|---|---|
| Input supply voltage | VIN | 3.8 | 5 | 6 | V | 4 | |
| Input supply current, charge mode | ICC | 250 | 500 | uA | Charge mode | 4 | |
| Input supply current, standby mode (charge ends) | ICC | 140 | 280 | uA | Standby mode (charge ends) | 4 | |
| Input supply current, shutdown mode | ICC | 140 | 280 | uA | Shutdown mode (RS not connected, VIN<VBAT or VIN<VUV) | 4 | |
| Regulated output voltage | VFLOAL | 4.307 | 4.35 | 4.393 | V | 0℃≤TA≤85℃ | 4 |
| BAT pin current, RS=0.1Ω | IBAT | 900 | 1000 | 1100 | mA | RS=0.1Ω,current mode | 4 |
| BAT pin current, RS=0.05Ω | IBAT | 1800 | 2000 | 2200 | mA | RS=0.05Ω,current mode | 4 |
| BAT pin current, standby mode | IBAT | 0 | -3 | -5 | uA | Standby mode,VBAT=4.35V | 4 |
| BAT pin current, shutdown mode | IBAT | -2 | 2 | uA | Shutdown mode (RPROG not connected) | 4 | |
| Trickle charge current | ITRIKL | 180 | 200 | 220 | mA | VBAT<VTRIKL,RPROG=0.05Ω | 4 |
| Trickle charge threshold voltage | VTRIKL | 2.8 | 2.9 | 3 | V | RS=0.05Ω,VBAT rising | 4 |
| Trickle charge hysteresis voltage | VTRHYS | 60 | 80 | 100 | mV | RS=0.05Ω | 5 |
| VCC under voltage lockout threshold | VUV | 3.6 | 3.7 | 3.9 | V | VIN from low to high | 5 |
| VCC under voltage lockout hysteresis | VUVHYS | 150 | 200 | 300 | mV | 5 | |
| VCC-VBAT lockout threshold voltage | VASD | 120 | 200 | 300 | mV | VIN from low to high | 5 |
| VCC-VBAT lockout hysteresis (unlabelled row) | 20 | 45 | 80 | mV | VIN from low to high | 5 | |
| C/10 termination current threshold, RS=0.1Ω | ITERM | 100 | mA | RS=0.1Ω | 5 | ||
| C/10 termination current threshold, RS=0.05Ω | ITERM | 200 | mA | RS=0.05Ω | 5 | ||
| NCHRG pin output low voltage | VNCHRG | 0.3 | 0.6 | V | INCHRG=5mA | 5 | |
| NSTDBY pin output low voltage | VNSTDBY | 0.3 | 0.6 | V | INSTDBY=5mA | 5 | |
| The voltage at TS increase | VTS_H | 80 | 82 | %VIN | 5 | ||
| The voltage at TS decrease | VTS_L | 43 | 45 | %VIN | 5 | ||
| Recharge battery threshold voltage | ΔVRECHRG | 50 | 100 | 150 | mV | VFLOAT-VRECHRG | 5 |
| Switching frequency | FREQ | 1.3 | 1.5 | 1.7 | MHz | 5 | |
| Thermal protection temperature | TLIM | 145 | ℃ | 5 | |||
| The on-resistance of P-FET | RPFET | 150 | mΩ | 5 | |||
| The on-resistance of N-FET | RNFET | 120 | mΩ | 5 | |||
| Soft-start time | tSS | 20 | us | IBAT=0 to IBAT=1200V/RPROG | 5 | ||
| Recharge comparator filter time | tRECHRG | 0.8 | 1.8 | 4 | ms | VBAT from high to low | 5 |
| Termination comparator filter time | tTERM | 0.8 | 1.8 | 4 | ms | IBAT below ICHRG/10 | 5 |
| Input voltage VIN absolute maximum | VIN | -0.3 | 6.5 | V | 1 | ||
| BAT absolute maximum | BAT | -0.3 | 7 | V | 1 | ||
| LX absolute maximum | LX | -0.3 | 7 | V | 1 | ||
| VS absolute maximum | VS | -0.3 | 7 | V | 1 | ||
| NCHRG absolute maximum | NCHRG | -0.3 | 8 | V | 1 | ||
| NSTDBY absolute maximum | NSTDBY | -0.3 | 8 | V | 1 | ||
| TS absolute maximum | TS | -0.3 | 8 | V | 1 | ||
| Maximum junction temperature | 145 | ℃ | 1 | ||||
| Storage temperature range | -65 | 125 | ℃ | 1 | |||
| Lead temperature (soldering) | 260 | ℃ | Soldering, 10 sec | 1 | |||
| Operating temperature range | -40 | 85 | ℃ | 1 |
CAD (KiCad official)
- Symbol:
SLM6550 - Footprint:
Package_SO:SOIC-8_3.9x4.9mm_P1.27mm - 3D model: SOP-8 (KiCad packages3D, STEP)
- 3D model files:
slm6550-etched.step/slm6550-etched.glbcarry the MPN laser-etched on the die in a toggleableAdom.LaserEtchgroup (Fusion-ready);slm6550.step/slm6550.glbare the bare package body.
Provenance
Data extracted from the manufacturer datasheet, not a distributor listing:
- Datasheet: SOLA-IC datasheet (12 pp, sha256
7462325598d3bd28, retrieved 2026-10-28, tier: lcsc) - Extractor: parts-factory
2.0.0/extract_pins 0.3, primaryclaude-haiku-5-5(text), consensusclaude-sonnet-5-5(agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish. - CAD: KiCad official libraries (CC-BY-SA 4.0).