main
Ray Publish 0.1.1 5ce986e

NSM2012-20B5R-DSPR

NOVOSENSE(纳芯微) · Current Sensors · SOIC-8

NSM2012-20B5R-DSPR from NOVOSENSE(纳芯微), in a SOIC-8. Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin Name Type Function
1 IP+ passive Primary current terminal where current flows into the chip, defined as the positive direction; datasheet lists pins 1-2 together as IP+ (rated for 5 V version, primary on-resistance 1.2 mΩ typ at 25 °C).
2 IP+ passive Second primary current terminal for current flowing into the chip in the positive direction, sharing the IP+ function listed as pins 1-2.
3 IP- passive Primary current terminal where current flows out of the chip, defined as the negative direction; datasheet lists pins 3-4 together as IP-.
4 IP- passive Second primary current terminal for current flowing out of the chip in the negative direction, sharing the IP- function listed as pins 3-4.
5 GND power_in Power ground reference for the device (the datasheet calls it 电源地, power ground).
6 VREF/NC power_in On the R (ratiometric) version this pin is not connected because the internal amplifier output is disconnected, and it may also be tied to GND; it is VREF only on the F (fixed-output) version.
7 VOUT output Analog output voltage proportional to the primary current; on the 5 V version the output swings rail-to-rail from 0.1 VCC to VCC-0.1 V with 10 kΩ load and up to 10 nF load capacitance, and short-circuit current is 25 mA.
8 VCC power_in Supply input; the 5 V version operates from 4.5 V to 5.5 V (absolute maximum -0.3 V to 6.5 V) with about 15 mA typical current at no load.

Key specifications

Parameter Value
Manufacturer NOVOSENSE(纳芯微)
Package SOIC-8
Category Magnetic Sensors
Pins 8

Electrical characteristics

Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).

Parameter Symbol Min Typ Max Unit Conditions Page
Supply voltage (5V version) VCC 4.5 5 5.5 V 5V supply version 5
Operating current (no load) ICC 12 15 mA No load, Vcc=5V 5
Primary conductor on-resistance RP 1.2 mΩ TA = 25℃ 5
Internal filter resistance Rfilter 4.7 kΩ 5
Power-on start time Tpo 1 ms Read data no earlier than 1ms after VCC reaches VCCmin 5
Output load capacitance CL 10 nF 5
Output load resistance RL 10 kΩ 5
Output short-circuit current Ishort 25 mA Vout shorted to VCC and shorted to GND, TA = 25℃ 5
Common-mode field rejection ratio CMFR 40 dB Printed as >40 5
Output rise time Tr 0.9 us Vout=2.2V, TA = 25℃, CL=1nF, 在3.3V,30AB量程测量,R版本 5
Output delay time Tpd 0.9 us Vout=2.2V, TA = 25℃, CL=1nF, 在3.3V,30AB量程测量,R版本 5
Output response time Tresponse 1.5 us Vout=1V, TA = 25℃, CL=1nF, 在3.3V,30AB量程测量,R版本 5
Bandwidth (-3dB) BW 400 kHz -3dB, CL=1nF, TA = 25℃, 在3.3V,30AB量程测量,R版本 5
Noise density ND 120 uArms/√Hz TA = 25℃, CL=1nF, VCC= 5V 5
Nonlinearity ENL -0.2 0.2 % Printed as ±0.2% 5
Ratiometric sensitivity error SERR 0.75 % R版本,VCC= 4.85V~5.15V,TA = 25℃ 6
Ratiometric zero-point relative error VOUT0R 0.1 % R版本,VCC= 4.85V~5.15V,TA = 25℃ 6
Current measurement range Ipr -20 20 A 8
Sensitivity Sens 100 mV/A Iprmin<Ipr<Iprmax 8
Sensitivity error Esens -1.5 1.5 % TA = 25℃~125℃ 8
Zero-point error VOE -10 10 mV TA = 25℃~125℃ 8
Total output error Etotal -1.5 1.5 % TA = 25℃~125℃ 8
Sensitivity lifetime drift Esens_drift -2.3 2.3 % 经过可靠性以后,TA = 25℃测试 8
Zero-point lifetime drift VOE_drift -12 12 mV 经过可靠性以后,TA = 25℃测试 8
Total error lifetime drift Etotal_drift -2.8 2.8 % 经过可靠性以后,TA = 25℃测试 8
Supply voltage VCC -0.3 6.5 V 25℃ 4
Storage temperature TStorage -40 150 ℃ 4
Operating temperature Toperation -40 125 ℃ 4
Operating temperature TA -40 125 ℃ VCC = 5V or 3.3V, unless otherwise specified 5
Junction temperature Tj -40 150 ℃ 4
ESD human body model VHBM -8 8 kV Printed as ±8 kV 4
ESD charged device model VCDM -2 2 kV Printed as ±2 kV 4
Latch-up -500 500 mA Printed as ±500 mA 4
Dielectric surge voltage Vsurge 6 kV IEC61000-4-5 1.2us/50us waveform 4
Isolation withstand voltage VISO 3000 Vrms 60s, per UL62368-1 4
Common-mode transient immunity CMTI 100 V/ns Printed as >100 V/ns; failure: output spike >100mV lasting >1us 4
Creepage distance Creepage 4 mm Minimum creepage 4
Clearance distance Clearance 4 mm Minimum clearance 4

CAD (KiCad official)

  • Symbol: NSM2012-20B5R-DSPR
  • Footprint: Package_SO:SOIC-8_3.9x4.9mm_P1.27mm
  • 3D model: SOIC-8 (KiCad packages3D, STEP)
  • 3D model files: nsm2012-20b5r-dspr-etched.step / nsm2012-20b5r-dspr-etched.glb carry the MPN laser-etched on the die in a toggleable Adom.LaserEtch group (Fusion-ready); nsm2012-20b5r-dspr.step / nsm2012-20b5r-dspr.glb are the bare package body.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

  • Datasheet: NOVOSENSE(纳芯微) datasheet (21 pp, sha256 4d67156ecd2b3706, retrieved 2026-11-09, tier: lcsc)
  • Datasheet language: Chinese. Pin names, descriptions, and specs on this page were extracted and translated to English by ds2sf; the linked PDF is the manufacturer original.
  • Extractor: parts-factory 2.0.0 / extract_pins 0.3, primary claude-haiku-5-5 (text), consensus claude-sonnet-5-5 (agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish.
  • CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF