← Commit history

Set visibility: public

Ray ·83d35f1b8c · ·parent de1c2c5
1 file changed +9−6
page.json+9−6
@@ -50,31 +50,31 @@         "number": "4",         "name": "PG",         "type": "output",-        "description": "Power Good - open-drain output from the Power-Good comparator. High-impedance when FB voltage is within regulation (rising threshold 0.54 V typ, falling 0.51 V typ); otherwise pulled low (VRPG \u2248 130 mV at 2.5 mA)."+        "description": "Power Good - open-drain output from the Power-Good comparator. High-impedance when FB voltage is within regulation (rising threshold 0.54 V typ, falling 0.51 V typ); otherwise pulled low (VRPG ≈ 130 mV at 2.5 mA)."       },       {         "number": "5",         "name": "EN",         "type": "input",-        "description": "Enable input. Logic high (>1.4 V) turns the part on; logic low (<0.4 V) shuts it off. An internal ~1.4 \u00b5A pull-up forces the part into the enabled state when the pin is left floating."+        "description": "Enable input. Logic high (>1.4 V) turns the part on; logic low (<0.4 V) shuts it off. An internal ~1.4 µA pull-up forces the part into the enabled state when the pin is left floating."       },       {         "number": "6",         "name": "FB",         "type": "input",-        "description": "Feedback input to the error amplifier. Connect a resistor divider from VOUT to this pin to program the regulated output; internal reference VFB \u2248 0.6 V."+        "description": "Feedback input to the error amplifier. Connect a resistor divider from VOUT to this pin to program the regulated output; internal reference VFB ≈ 0.6 V."       },       {         "number": "7",         "name": "SS",         "type": "passive",-        "description": "Soft-start. An external capacitor to GND sets the soft-start ramp time (charged by ISS \u2248 0.7 \u00b5A). Leaving the pin open uses the default 500 \u00b5s internal soft-start. (On NCP1593B this pin is NC and must be left floating.)"+        "description": "Soft-start. An external capacitor to GND sets the soft-start ramp time (charged by ISS ≈ 0.7 µA). Leaving the pin open uses the default 500 µs internal soft-start. (On NCP1593B this pin is NC and must be left floating.)"       },       {         "number": "8",         "name": "VCCA",         "type": "power_in",-        "description": "Analog/internal-bias supply input (called VCC in the pin table, VCCA in the pin-connection diagram and application circuit). Bypass with a 0.1 \u00b5F ceramic capacitor to GND and tie directly to VCCP on the board. Range 4.0 V to 5.5 V."+        "description": "Analog/internal-bias supply input (called VCC in the pin table, VCCA in the pin-connection diagram and application circuit). Bypass with a 0.1 µF ceramic capacitor to GND and tie directly to VCCP on the board. Range 4.0 V to 5.5 V."       },       {         "number": "9",@@ -166,5 +166,8 @@     "docs/ncp1593amntwg-datasheet.pdf",     "viewers/symbol.html",     "viewers/footprint.html"-  ]+  ],+  "visibility": {+    "public": true+  } }\ No newline at end of file