main
History Download
Ray Publish 0.1.0 b4c0565

LM5158RTER

Texas Instruments · DC-DC Converters · WQFN-16(3x3)

LM5158RTER from Texas Instruments, in a WQFN-16(3x3). Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin Name Type Function
1 PGND power_in Power ground pin and source connection of the internal N-channel power MOSFET (pins 1 and 16 are both PGND).
2 VCC power_out Output of the internal VCC regulator and supply input of the internal MOSFET driver; connect a 1-µF ceramic bypass capacitor from this pin to PGND.
3 BIAS power_in Supply voltage input to the VCC regulator (3.2 V to 60 V operating); connect a bypass capacitor from this pin to PGND.
4 PGOOD output Open-drain power-good indicator that goes low if FB is below the undervoltage threshold (VUVTH); connect a pullup resistor to the system voltage rail.
5 RT input Switching frequency setting pin; frequency is programmed by a single resistor between RT and AGND.
6 EN/UVLO/SYNC input Enable, programmable line UVLO and external synchronization clock input (negative pulse); converter shuts down below the enable threshold (VEN), must not be left floating, and should be connected to BIAS if not used.
7 AGND power_in Analog ground pin; connect to the analog ground plane through a wide and short path.
8 COMP output Output of the internal transconductance error amplifier; connect the loop compensation components between this pin and AGND.
9 FB input Inverting input of the error amplifier; connect a voltage divider to set the output voltage, with the low-side feedback resistor as close to AGND as possible.
10 SS input Soft-start time programming pin; an external capacitor to AGND and an internal current source set the reference ramp rate during soft start.
11 MODE input Selects hiccup mode protection and spread spectrum at initial power up: 0 V/AGND = both disabled, 370 mV/37.4 kΩ = hiccup and spread spectrum enabled, 620 mV/62.0 kΩ = hiccup enabled and spread spectrum disabled, >1 V/100 kΩ = hiccup disabled and spread spectrum enabled.
12 NC unconnected No internal electrical contact.
13 SW passive Switch pin and drain connection of the internal N-channel power MOSFET (85 V absolute maximum DC).
14 SW passive Switch pin and drain connection of the internal N-channel power MOSFET (85 V absolute maximum DC).
15 NC unconnected No internal electrical contact.
16 PGND power_in Power ground pin and source connection of the internal N-channel power MOSFET (pins 1 and 16 are both PGND).
17 EP passive Exposed pad (from the footprint; not named in the datasheet pin table).

Key specifications

Parameter Value
Manufacturer Texas Instruments
Package WQFN-16(3x3)
Category Power Supply Chip
Pins 17

Electrical characteristics

Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).

Parameter Symbol Min Typ Max Unit Conditions Page
BIAS to AGND -0.3 65 V 6
UVLO to AGND -0.3 V max is VBIAS + 0.3 V 6
SS, RT to AGND -0.3 3.8 V 6
FB to AGND -0.3 4 V 6
MODE to AGND -0.3 3.8 V 6
PGND to AGND -0.3 0.3 V 6
VCC to AGND -0.3 5.8 V 6
PGOOD to AGND -0.3 18 V 6
SW to AGND (DC) -0.3 85 V DC 6
SW to AGND (5-ns transient) -6 V 5-ns transient 6
Junction temperature TJ -40 150 °C 6
Storage temperature Tstg -55 150 °C 6
ESD HBM V(ESD) -2000 2000 V ANSI/ESDA/JEDEC JS-001, all pins 6
ESD CDM V(ESD) -500 500 V ANSI/ESDA/JEDEC JS-002 6
Boost converter input VSUPPLY 1.5 60 V when BIAS ≥ 3.2 V 6
Boost converter output VLOAD 83 V min is VSUPPLY 6
BIAS input VBIAS 3.2 60 V 6
UVLO input VUVLO 0 60 V 6
FB input VFB 0 4 V 6
Typical switching frequency fSW 100 2200 kHz 6
Synchronization pulse frequency fSYNC 100 2200 kHz 6
Operating junction temperature TJ -40 125 °C 6
BIAS shutdown current ISHUTDOWN(BIAS) 2.6 5 μA VBIAS = 12 V, VUVLO = 0 V 7
BIAS operating current IOPERATING(BIAS) 670 850 μA VBIAS = 12 V, VUVLO = 2.0 V, VFB = VREF, RT = 220 kΩ 7
VCC regulation VVCC-REG 4.66 4.9 5.14 V VBIAS = 8 V, IVCC = 18 mA 7
VCC UVLO threshold VVCC-UVLO(RISING) 3.05 3.1 3.15 V VCC rising 7
Enable threshold rising VEN(RISING) 0.4 0.52 0.7 V EN rising 7
Enable threshold falling VEN(FALLING) 0.33 0.49 0.63 V EN falling 7
UVLO threshold rising VUVLO(RISING) 1.425 1.5 1.575 V UVLO rising 7
UVLO threshold falling VUVLO(FALLING) 1.37 1.45 1.52 V UVLO falling 7
UVLO hysteresis current IUVLO 4 5 6 μA VUVLO = 1.6 V 7
Soft-start current ISS 9 10 11 μA 7
Switching frequency fsw1 85 100 115 kHz RT = 220 kΩ 7
Switching frequency fsw2 388 440 492 kHz RT = 49.3 kΩ 8
Switching frequency fsw3 1980 2200 2420 kHz RT = 9.09 kΩ 8
Maximum duty cycle limit DMAX1 80 85 90 % RT = 9.09 kΩ 8
Maximum duty cycle limit DMAX2 90 93 96 % RT = 220 kΩ 8
Internal MOSFET current limit LM5158 ILIM 3.26 3.75 4.24 A LM5158 8
FB reference VREF 0.99 1 1.01 V 8
COMP clamp voltage rising 2.5 2.8 V COMP rising (VUVLO = 2.0 V) 8
COMP clamp voltage falling 1 1.1 V COMP falling 8
Overvoltage threshold rising VOVTH 107 110 113 % FB rising (reference to VREF) 8
Undervoltage threshold falling VUVTH 87 90 93 % FB falling (reference to VREF) 8
Internal MOSFET on-resistance rDS(ON) 133 290 mΩ VBIAS = 12 V 8
Internal MOSFET on-resistance rDS(ON) 138 300 mΩ VBIAS = 3.5 V 8
Switch leakage current 1100 nA VSW = 12 V 8
Thermal shutdown threshold TTSD 175 °C Temperature rising 8
Junction-to-ambient thermal resistance RθJA 45.6 °C/W RTE(QFN) 16 pins 7
Junction-to-ambient thermal resistance (EVM) RθJA 32.7 °C/W LM5158EVM-BST 7
Junction-to-case (top) thermal resistance RθJC(top) 44.8 °C/W 7
Junction-to-board thermal resistance RθJB 19.1 °C/W 7
Junction-to-case (bottom) thermal resistance RθJC(bot) 6.7 °C/W 7

CAD (KiCad official)

  • Symbol: LM5158RTER
  • Footprint: Package_DFN_QFN:QFN-16-1EP_3x3mm_P0.5mm_EP1.7x1.7mm
  • 3D model: WQFN-16(3x3) (KiCad packages3D, STEP)
  • 3D model files: lm5158rter-etched.step / lm5158rter-etched.glb carry the MPN laser-etched on the die in a toggleable Adom.LaserEtch group (Fusion-ready); lm5158rter.step / lm5158rter.glb are the bare package body.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

  • Datasheet: Texas Instruments datasheet (45 pp, sha256 9e8875f070157c1d, retrieved 2026-10-26, tier: lcsc)
  • Datasheet language: Chinese. Pin names, descriptions, and specs on this page were extracted and translated to English by ds2sf; the linked PDF is the manufacturer original.
  • Extractor: parts-factory 2.0.0 / extract_pins 0.3, primary claude-sonnet-5-5 (text), consensus claude-sonnet-5-5 (agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish.
  • CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF