M24C02-FMN6TP from STMicroelectronics, in a SOIC-8. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin	Name	Type	Function
1	E0	input	Chip Enable address input bit 0. Sets bit b1 of the 7-bit I2C device select code; must be tied to VCC or VSS. Reads as 0 if left floating.
2	E1	input	Chip Enable address input bit 1. Sets bit b2 of the 7-bit I2C device select code; must be tied to VCC or VSS. Reads as 0 if left floating.
3	E2	input	Chip Enable address input bit 2. Sets bit b3 of the 7-bit I2C device select code; must be tied to VCC or VSS. Reads as 0 if left floating.
4	VSS	power_in	Ground reference for VCC supply voltage.
5	SDA	bidirectional	I2C Serial Data input/output. Open-drain output; requires an external pull-up resistor to VCC. Wire-OR compatible with other open-drain devices on the bus.
6	SCL	input	I2C Serial Clock input. Strobes data on SDA(in) and clocks out data on SDA(out). Supports 100 kHz Standard-mode and 400 kHz Fast-mode.
7	WC	input	Write Control (active-low). When driven high, writes to the memory array are inhibited (data bytes are NACK'd); when driven low or left floating, writes are enabled.
8	VCC	power_in	Positive supply voltage. M24C02-F: 1.7 V to 5.5 V over full temperature range (1.6 V to 1.7 V allowed for 0-85 degC limited range). Decouple with 10 nF to 100 nF close to the VCC/VSS pins.

Key specifications

Parameter	Value
Manufacturer	STMicroelectronics
Package	SOIC-8
Category	Memory
Pins	8

Ordering variants

Same part, different packaging or reel option.

M24C02-FMN6TP
M24C02-FMN6TPDW
M24C02-FMN6TPBN
M24C02-FMN6TPMC
M24C02-FMN6TPMH

CAD (KiCad official)

Symbol: M24C02-FMN6TP
Footprint: Package_SO:SOIC-8_3.9x4.9mm_P1.27mm
3D model: SOIC-8 (KiCad packages3D, STEP)

3D model downloads

Two STEP files. Same geometry, different body top:

File	Size	Use it when
`m24c02-fmn6tp.step`	122 KB	You want the bare part, or you mark your own boards.
`m24c02-fmn6tp-etched.step`	2.3 MB	You want the part with `M24C02-FMN6TP` already on it.

The marking in the etched file is real recessed geometry cut into the solid, not a texture or a decal: 571 faces against 147 in the bare model. It survives export, section views, and rendering in any CAD tool, and it drops straight into KiCad or Fusion with no extra setup.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

Datasheet: STMicroelectronics datasheet (42 pp, sha256 943c0b9f52652f9b, retrieved 2026-08-17, tier: manufacturer)
Extractor: ds2sf (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.
CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF