component
AP2411AMP-13
Public Unreviewedby Ray
Diodes Incorporated AC-DC Controllers and Regulators, MSOP-8-EP. Datasheet-verified pinout, KiCad symbol/footprint/3D.
3D Model
Open in new tab ↗
Symbol & Footprint
Schematic Symbol
Open full view ↗PCB Footprint
Open full view ↗Datasheet
Open in new tab ↗README
markdownAP2411AMP-13
Diodes Incorporated · AC-DC Controllers and Regulators · MSOP-8-EP
AP2411AMP-13 from Diodes Incorporated, in a MSOP-8-EP. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.
Pinout
| Pin | Name | Type | Function |
|---|---|---|---|
| 1 | GND | power_in | Ground reference for the device. All internal voltages are referred to this pin. |
| 2 | IN | power_in | Voltage input pin (2.7 V to 5.5 V). Both IN pins (2 and 3) must be tied together externally. Connect a 0.1 µF or larger ceramic capacitor from IN to GND as close as possible. |
| 3 | IN | power_in | Voltage input pin (2.7 V to 5.5 V). Both IN pins (2 and 3) must be tied together externally. |
| 4 | EN | input | Enable input. Active-high on AP2411A (this variant). VIL max 0.8 V, VIH min 2 V. Typical input leakage 0.01 µA (max 1 µA) at VIN = 5 V. |
| 5 | FLG | output | Over-temperature and over-current fault reporting output. Active-low open-drain (requires external pull-up; typ 10 kΩ to logic supply). Reports faults after a 7 ms typ blanking/deglitch time and is disabled for 7 ms after turn-on. FLG on-resistance ~25 Ω typ at IFLG = 10 mA. |
| 6 | OUT | power_out | Voltage output pin. Both OUT pins (6 and 7) must be tied together externally. Typical 70 mΩ Rds(on) switch to IN when enabled; current limited to ~2.5 A typ with latch-off after 7 ms deglitch on overcurrent. |
| 7 | OUT | power_out | Voltage output pin. Both OUT pins (6 and 7) must be tied together externally. |
| 8 | NC | unconnected | No internal connection. Datasheet recommends tying this pin to the OUT pins. |
Key specifications
| Parameter | Value |
|---|---|
| Manufacturer | Diodes Incorporated |
| Package | MSOP-8-EP |
| Category | PMIC |
| Pins | 8 |
Ordering variants
Same part, different packaging or reel option.
AP2411AMP-13
CAD (KiCad official)
- Symbol:
AP2411AMP-13 - Footprint:
Package_SO:MSOP-8-1EP_3x3mm_P0.65mm_EP1.5x1.8mm - 3D model: MSOP-8-EP (KiCad packages3D, STEP)
Provenance
Data extracted from the manufacturer datasheet, not a distributor listing:
- Datasheet: Diodes Incorporated datasheet (18 pp, sha256
0867d4d4385bb394, retrieved 2026-08-17, tier: lcsc) - Extractor:
ds2sf(Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate. - CAD: KiCad official libraries (CC-BY-SA 4.0).