Hardware
Hardware: components, molecules, projects, and equipment with symbols, footprints, and 3D models.
21 hardware pages matching
tmf8829-adapter-molecule
TMF8829 breakout onto a 32 x 32 mm machine-pin datum
adom-wiki pkg install adom/tmf8829-adapter-molecule
ranger-micro-breakout-molecule-extended
U.FL + SMP + YAT attenuator breakout — 104 x 104 mm
adom-wiki pkg install adom/ranger-micro-breakout-molecule-extended
rp1-breakout-molecule-extended
U.FL + SMP + YAT attenuator on a machine-pin breakout — 104 x 104 mm
adom-wiki pkg install adom/rp1-breakout-molecule-extended
combiner-molecule
Two Mini-Circuits EP2W+ combiners, four SMP jacks — 104 x 104 mm
adom-wiki pkg install adom/combiner-molecule
coax-antennuator-molecule-32x32
Inline Mini-Circuits YAT attenuator between two SMP jacks
adom-wiki pkg install adom/coax-antennuator-molecule-32x32
coax-molecule-2ch-64x64
Four Amphenol SMP jacks — two coax channels — 64 x 64 mm
adom-wiki pkg install adom/coax-molecule-2ch-64x64
coax-molecule-32x32
Two Amphenol SMP jacks on a 32 x 32 mm datum
adom-wiki pkg install adom/coax-molecule-32x32
rf-mech-molecule-64x64
Mechanical datum — machine pins + mounting holes — 64 x 64 mm
adom-wiki pkg install adom/rf-mech-molecule-64x64
rf-mech-molecule-32x64
Mechanical datum — machine pins + mounting holes — 32 x 64 mm
adom-wiki pkg install adom/rf-mech-molecule-32x64
rf-mech-molecule-32x32
Mechanical datum — machine pins + mounting holes — 32 x 32 mm
adom-wiki pkg install adom/rf-mech-molecule-32x32
Drone Motor Carrier
Passive baseplate for the single-motor drone test cell: mounts the BLDC motor, passes its three phases through, routes two load-cell channels, and nests the RP2350A/ADS1220 acquisition molecule and a PiProbe over a 96 x 96 mm machine-pin datum. 104 x 104 mm, 4-layer.
adom-wiki pkg install adom/drone-motor-carrier
FC Carrier (RP2350A-Mini)
Flight-controller carrier for the single-motor drone cell: hosts the RP2350A-Mini, bridges 5 V to two loads, monitors the 5 V rail into the mini's ADC, and carries a hardware E-stop that drives the ESC brake. 38.8 x 70.8 mm, 4-layer, 32 x 64 mm datum.
adom-wiki pkg install adom/carrier-fc-rp2350a-mini
RP2350A + ADS1220 Molecule
24-bit thrust-acquisition molecule for the drone motor carrier: an RP2350A paired with a TI ADS1220 24-bit ADC, W25Q16JV flash and AP2112K-3.3 LDO, with a ratiometric load-cell front-end. Nests on the motor carrier over machine pins.
adom-wiki pkg install adom/rp2350a-ads1220
ESC G431
Single-motor ESC for the drone test cell: STM32G431 + DRV8300 driving a 3-phase bridge of six BSC016N06NS MOSFETs, TPSM365 buck to 12 V, INA181 low-side current sense (25 mV/A, 131 A full-scale). Runs AM32. 64 x 74 mm, 4-layer.
adom-wiki pkg install adom/esc-g431
rf-scaffold-module
SMP to SMPM edge, on a machine-pin datum — 32 x 88 mm
adom-wiki pkg install adom/rf-scaffold-module
rf-workcell-module
SMPM blind-mate to SMA end-launch — 41 x 64 mm
adom-wiki pkg install adom/rf-workcell-module
tmf8829-molecule
ams OSRAM TMF8829 direct time-of-flight sensor · 16 x 21 mm
adom-wiki pkg install adom/tmf8829-molecule
RP2040 Breakout — KiCad Bridge Pipeline Demo
RP2040 breakout board pushed end-to-end through the Adom KiCad bridge molecule pipeline: kicad_export_molecule (STEP + ray-traced silkscreen renders on a GPU VM) -> step2glb color-preserving GLB -> adom-molecule. Annotated silks (U1/C1-C5/Y1/J1), USB-C, 12 MHz crystal, QFN-56 RP2040.
adom-wiki pkg install john/rp2040-breakout-pipeline-demo
rp2350a-mini
General-purpose RP2350A castellated module — 20×36 mm, dual-core Arm Cortex-M33 / Hazard3 RISC-V MCU with 16 Mbit QSPI flash, USB, UART, SWD debug, and 4 ADC channels. 26 user-programmable GPIO/ADC pins on castellated machine contacts (44 contacts + 4 corner machine pins). Drop-in MCU module for Adom workcell designs.
adom-wiki pkg install adom/rp2350a-mini
I2S: Carrier
I2S_Carrier_v1.0: Carrier for I2S MEMs Microphones, standardized to fit all MEMs varients. Jumper selects Left or Right.
adom-wiki pkg install caleb/i2s-carrier
piprobe-v1-3
PiProbe_v1.3: RP2040-based SWD debug probe molecule — 28×20 mm, CMSIS-DAP with SWD debug + UART passthrough, 9 machine contacts + 4 machine pins. Runs Raspberry Pi Debugprobe firmware. Flash and debug
adom-wiki pkg install adom/piprobe-v1-3