65% MX Keyboard (soldered)

@@ -58,6 +58,8 @@ Every step of the build, in order, each with its own page of evidence (checks, s  **5. 3D models**: every 3D model bound and upright. [The evidence](steps/05-models/README.md) +**6. Test plan**: what to measure on the workcell, a probe spot for each. [The evidence](steps/06-test-plan/README.md)+ **7. Placement**: parts placed for current and heat. [The evidence](steps/07-placement/README.md)  **8. Routing**: every trace routed, DRC clean. [The evidence](steps/08-routing/README.md)

@@ -0,0 +1,28 @@+# Step 6: Test plan++Think through how this board will be tested once it is built and on the probing workcell: the measurements a careful engineer would take (rails, switch node, feedback, ripple, enable, LEDs), the net each one needs, and a probe spot for every one. The binary checks each planned measurement has a probe-able spot (a 0.5 mm round test point or an exposed pad the pogo tip can land on, within 50 mm of a ground machine contact, not under a part body) and adds a test point to the netlist for every gap.++## Visits++- 2026-11-09T06:17:06Z++## What the binary checked++### testplan++- **added**: 0 item(s)+- **file**: /home/adom/project/keyboard65/design/tests.json+- **gaps**: 0 item(s)+- **mode**: board+- **notes**: no MachineContactMedium on GND: the ground tether has nowhere to plug in (add one near each corner, adom/probing-workcell)+- **tests**: 7 item(s)++## Screenshots and drawings++**start**++![start](shot-test-plan-1-start.png)++**visit 1-start**++![visit 1-start](shot-test-plan-1-start.png)

⋯ 1 unchanged line ⋯