← Commit history
page.json+9−6@@ -32,7 +32,7 @@ "number": "1", "name": "BOOT", "type": "power_in",- "description": "Power supply bias for the high-side power MOSFET gate driver. Connect a 0.1\u00b5F bootstrap capacitor from BOOT to SW; the cap charges when SW is low. Absolute max 71V (BOOT-SW max 6V)."+ "description": "Power supply bias for the high-side power MOSFET gate driver. Connect a 0.1µF bootstrap capacitor from BOOT to SW; the cap charges when SW is low. Absolute max 71V (BOOT-SW max 6V)." }, { "number": "2",@@ -44,7 +44,7 @@ "number": "3", "name": "EN", "type": "input",- "description": "Enable pin with internal pull-up (1\u00b5A/4\u00b5A). Pull below 1.05V to disable; float or tie to VIN to enable. A resistor divider from VIN to GND on EN programs the input UVLO threshold (VEN_H = 1.2V typ)."+ "description": "Enable pin with internal pull-up (1µA/4µA). Pull below 1.05V to disable; float or tie to VIN to enable. A resistor divider from VIN to GND on EN programs the input UVLO threshold (VEN_H = 1.2V typ)." }, { "number": "4",@@ -56,13 +56,13 @@ "number": "5", "name": "FB", "type": "input",- "description": "Inverting input of the trans-conductance error amplifier. External resistor divider from VOUT to GND to FB sets the output voltage; the device regulates FB to the internal 0.8V \u00b11% reference."+ "description": "Inverting input of the trans-conductance error amplifier. External resistor divider from VOUT to GND to FB sets the output voltage; the device regulates FB to the internal 0.8V ±1% reference." }, { "number": "6", "name": "SS", "type": "passive",- "description": "Soft-start programming pin. Connect a capacitor from SS to GND; an internal 3\u00b5A source charges CSS to program soft-start time (tSS = CSS \u00d7 0.8V / 3\u00b5A). Programmed soft-start time should be greater than 4ms."+ "description": "Soft-start programming pin. Connect a capacitor from SS to GND; an internal 3µA source charges CSS to program soft-start time (tSS = CSS × 0.8V / 3µA). Programmed soft-start time should be greater than 4ms." }, { "number": "7",@@ -80,7 +80,7 @@ "number": "9", "name": "Thermal Pad", "type": "passive",- "description": "Exposed die-attach pad for heat dissipation. Electrically connected to GND (pin 7) and must be soldered to the PCB ground plane for correct operation and optimized thermal performance (\u03b8JA = 42\u00b0C/W on the standard board)."+ "description": "Exposed die-attach pad for heat dissipation. Electrically connected to GND (pin 7) and must be soldered to the PCB ground plane for correct operation and optimized thermal performance (θJA = 42°C/W on the standard board)." } ], "provenance": {@@ -144,5 +144,8 @@ "docs/sct2632aster-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }