component
OPA695IDBVR
Public Made by Adomby adom
Texas Instruments Operational Amplifier, SOT-23-6. Pinout extracted from the datasheet, KiCad symbol/footprint/3D.
← Commit history
page.json+10−7@@ -32,37 +32,37 @@ "number": "1", "name": "Output", "type": "output",- "description": "Op-amp output. Drives \u00b14.2 V into typical loads on a \u00b15 V supply; large-signal bandwidth 450 MHz at G=+8, VO=4 VPP."+ "description": "Op-amp output. Drives ±4.2 V into typical loads on a ±5 V supply; large-signal bandwidth 450 MHz at G=+8, VO=4 VPP." }, { "number": "2", "name": "-Vs", "type": "power_in",- "description": "Negative supply rail. Typical split-supply operation \u00b15 V; recommended range \u00b12.5 V to \u00b16 V. Bypass locally with a low-ESR ceramic to ground."+ "description": "Negative supply rail. Typical split-supply operation ±5 V; recommended range ±2.5 V to ±6 V. Bypass locally with a low-ESR ceramic to ground." }, { "number": "3", "name": "Non-inverting Input", "type": "input",- "description": "High-impedance non-inverting input (+IN) of the current-feedback amplifier. Input common-mode voltage rating \u00b1Vs (see absolute maximums)."+ "description": "High-impedance non-inverting input (+IN) of the current-feedback amplifier. Input common-mode voltage rating ±Vs (see absolute maximums)." }, { "number": "4", "name": "Inverting Input", "type": "input",- "description": "Low-impedance inverting input (-IN) of the current-feedback amplifier; feedback resistor RF (typ. 348-523 \u03a9 depending on gain) connects here. Sets loop gain and bandwidth in a CFB topology."+ "description": "Low-impedance inverting input (-IN) of the current-feedback amplifier; feedback resistor RF (typ. 348-523 Ω depending on gain) connects here. Sets loop gain and bandwidth in a CFB topology." }, { "number": "5", "name": "DIS", "type": "input",- "description": "Active-low disable / enable control (labeled \"Not disable (Enable)\" in the pin table, bar over DIS in the pinout drawing). Leave floating or hold HIGH for normal operation; pull LOW to place the amplifier in a low-power state (supply drops to <170 \u00b5A, 0.5 mW)."+ "description": "Active-low disable / enable control (labeled \"Not disable (Enable)\" in the pin table, bar over DIS in the pinout drawing). Leave floating or hold HIGH for normal operation; pull LOW to place the amplifier in a low-power state (supply drops to <170 µA, 0.5 mW)." }, { "number": "6", "name": "+Vs", "type": "power_in",- "description": "Positive supply rail. Typical split-supply operation \u00b15 V; recommended range \u00b12.5 V to \u00b16 V (single-supply 5-12 V also supported). Bypass locally with a low-ESR ceramic to ground."+ "description": "Positive supply rail. Typical split-supply operation ±5 V; recommended range ±2.5 V to ±6 V (single-supply 5-12 V also supported). Bypass locally with a low-ESR ceramic to ground." } ], "provenance": {@@ -126,5 +126,8 @@ "docs/opa695idbvr-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }