Loads when you scroll to it. Unloads after 5 minutes in the background.

Symbol & Footprint

Schematic Symbol

Open full view ↗
Loads when you scroll to it. Unloads after 5 minutes in the background.

PCB Footprint

Open full view ↗
Loads when you scroll to it. Unloads after 5 minutes in the background.
Loads when you scroll to it. Unloads after 5 minutes in the background.
Download PDF
Contents

README

markdown

LMR33630CDDAR

Texas Instruments · DC-DC Converters · SO-8

LMR33630CDDAR from Texas Instruments, in a SO-8. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin Name Type Function
1 PGND power_in Power ground terminal; connect to system ground and AGND with bypass capacitor using short wide traces.
2 VIN power_in Input supply to regulator; connect high-quality bypass capacitors directly to this pin and PGND.
3 EN input Enable input to regulator with high = ON and low = OFF; can be connected directly to VIN but must not float.
4 PG output Open-drain power-good flag output that pulls low when EN is low or during fault conditions; connect through current-limiting resistor to suitable supply.
5 FB input Feedback input to regulator connected to tap point of feedback voltage divider; must not float or be grounded.
6 VCC power_out Internal 5V LDO output for internal control circuits; connect high-quality 1µF capacitor from this pin to GND and do not connect to external loads.
7 BOOT power_out Bootstrap supply voltage for internal high-side driver; connect high-quality 100nF capacitor from this pin to SW pin.
8 SW output Regulator switch node connecting to power inductor; actively driven between VIN and GND by internal MOSFET switching network.

Key specifications

Parameter Value
Manufacturer Texas Instruments
Package SO-8
Category Power Management (PMIC)
Pins 8

Electrical characteristics

Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).

Parameter Symbol Min Typ Max Unit Conditions Page
Minimum operating input voltage VIN 3.8 V 6
Absolute max VIN to PGND VIN -0.3 38 V 5
Absolute max EN to AGND EN -0.3 V 5
Absolute max FB to AGND FB -0.3 5.5 V 5
Absolute max PG to AGND PG 0 22 V 5
Absolute max AGND to PGND AGND -0.3 0.3 V 5
Absolute max SW to PGND SW -0.3 V 5
Absolute max SW to PGND transient SW -3.5 38 V less than 100-ns transients 5
Absolute max BOOT to SW BOOT -0.3 5.5 V 5
Absolute max VCC to AGND VCC -0.3 5.5 V 5
Junction temperature TJ -40 150 °C 5
Storage temperature Tstg -55 150 °C 5
Input voltage VIN to PGND VIN 3.8 36 V 5
EN input voltage EN 0 V 5
PG voltage PG 0 18 V 5
Adjustable output voltage VOUT 1 24 V 5
Output current IOUT 0 3 A 5
VEN-H EN threshold rising VEN-H 1.2 1.231 1.26 V Rising threshold 6
Internal LDO output voltage VCC 4.75 5 5.25 V 6 V ≤ VIN ≤ 36 V 6
Feedback voltage (ADJ option) VFB 0.985 1 1.015 V ADJ option 6
Current into FB pin (ADJ option) IFB 0.2 50 nA ADJ option; FB = 1 V 6
Non-switching input current IQ 24 34 µA VFB = 1.2 V 6
Shutdown quiescent current ISD 5 10 µA EN = 0 V 6
High-side current limit LMR33630 ISC 3.85 4.5 5.05 A LMR33630 6
Low-side current limit LMR33630 ILIMIT 2.9 3.5 4.1 A LMR33630 6
Internal soft-start time tSS 2.9 4 6 ms 7
Power-good upper threshold rising VPG-HIGH-UP 105 107 110 % % of FB voltage 7
Power-good upper threshold falling VPG-HIGH-DN 103 105 108 % % of FB voltage 7
Power-good lower threshold rising VPG-LOW-UP 92 94 97 % % of FB voltage 7
Power-good lower threshold falling VPG-LOW-DN 90 92 95 % % of FB voltage 7
Power-good glitch filter delay tPG 60 170 µs 7
Power-good flag RDSON RPG 76 150 Ω VIN = 12 V, VEN = 4 V 7
Power-good flag RDSON RPG 35 60 Ω VEN = 0 V 7
Switching frequency C version, DDA package ƒSW 1.8 2.1 2.4 MHz C version, DDA package 7
High-side MOSFET ON-resistance DDA package RDS-ON-HS 95 160 mΩ DDA package 7
Low-side MOSFET ON-resistance DDA package RDS-ON-LS 66 110 mΩ DDA package 7
Minimum switch on-time DDA package tON-MIN 75 108 ns DDA package 7
Minimum switch off-time DDA package tOFF-MIN 50 85 ns DDA package 7
Maximum switch on-time tON-MAX 7 9 µs 7
Output voltage regulation for VOUT = 5 V VOUT -1.5 2.5 % VOUT = 5 V, VIN = 7 V to 36 V, IOUT = 0 A to max. load 8
Output voltage regulation for VOUT = 5 V VOUT -1.5 1.5 % VOUT = 5 V, VIN = 7 V to 36 V, IOUT = 1 A to max. load 8
Output voltage regulation for VOUT = 3.3 V VOUT -1.5 2.5 % VOUT = 3.3 V, VIN = 3.8 V to 36 V, IOUT = 0 A to max. load 8
Output voltage regulation for VOUT = 3.3 V VOUT -1.5 1.5 % VOUT = 3.3 V, VIN = 3.8 V to 36 V, IOUT = 1 A to max. load 8
Thermal resistance junction-to-ambient RθJA RθJA 42.9 °C/W DDA (HSOIC) 8 pins 6
Thermal resistance junction-to-case (top) RθJC(top) RθJC(top) 54 °C/W DDA (HSOIC) 8 pins 6
Thermal resistance junction-to-board RθJB RθJB 13.6 °C/W DDA (HSOIC) 8 pins 6
Thermal resistance junction-to-case (bottom) RθJC(bot) RθJC(bot) 4.3 °C/W DDA (HSOIC) 8 pins 6
EN input level to turn on internal LDO VEN-VCC-H 1 V Rising threshold 6
EN input level to turn off internal LDO VEN-VCC-L 0.3 V Falling threshold 6
Enable input leakage current ILKG-EN 0.2 nA VEN = 3.3 V 6
Bootstrap voltage undervoltage lock-out threshold VBOOT-UVLO 2.2 V 6
Minimum peak inductor current LMR33630 IPEAK-MIN 0.69 A LMR33630 6
Zero current detector threshold IZC -0.106 A 7
Minimum input voltage for proper PG function VIN-PG 2 V 50-µA, EN = 0 V 7
PG logic low output VPG 0.2 V 50-µA, EN = 0 V, VIN = 2V 7
Dropout voltage (VIN - VOUT) VDROP 150 mV VOUT = 5 V, IOUT = 1A; dropout at -1% of regulation, ƒSW = 140 kHz 8
Maximum switch duty cycle DMAX 98 % VIN = VOUT = 12 V, IOUT = 1 A 8
FB pin voltage to trip short-circuit hiccup mode VHC 0.4 V 8
Time between current-limit hiccup burst tHC 94 ms 8

CAD (KiCad official)

  • Symbol: LMR33630CDDAR
  • Footprint: Package_SO:SOIC-8_3.9x4.9mm_P1.27mm
  • 3D model: SO-8 (KiCad packages3D, STEP)
  • 3D model files: lmr33630cddar-etched.step / lmr33630cddar-etched.glb carry the MPN laser-etched on the die in a toggleable Adom.LaserEtch group (Fusion-ready); lmr33630cddar.step / lmr33630cddar.glb are the bare package body.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

  • Datasheet: Texas Instruments datasheet (57 pp, sha256 71bca20c1f8dd624, retrieved 2026-09-23, tier: lcsc)
  • Datasheet language: Chinese. Pin names, descriptions, and specs on this page were extracted and translated to English by ds2sf; the linked PDF is the manufacturer original.
  • Extractor: parts-factory 2.0.0 / extract_pins 0.2, primary claude-haiku-4-5-20251001 (text), consensus claude-sonnet-5 (agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish.
  • CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF