← Commit history
page.json+14−11@@ -65,7 +65,7 @@ "number": "3", "name": "SW", "type": "input",- "description": "Battery sensing disconnect switch terminal; top node of OV/UVLO resistor ladder; internal switch resistance 10-46 \u03a9 (3-65 V) disconnects ladder when EN or SLEEP is low to eliminate leakage."+ "description": "Battery sensing disconnect switch terminal; top node of OV/UVLO resistor ladder; internal switch resistance 10-46 Ω (3-65 V) disconnects ladder when EN or SLEEP is low to eliminate leakage." }, { "number": "4",@@ -83,13 +83,13 @@ "number": "6", "name": "EN", "type": "input",- "description": "Enable input; logic high enables charge pump and gate drivers; falling below V(ENF) 0.41-0.98 V places device in shutdown at 2.5-5 \u00b5A; connect to VS for always-ON; withstands 0-65 V, leakage 55-200 nA."+ "description": "Enable input; logic high enables charge pump and gate drivers; falling below V(ENF) 0.41-0.98 V places device in shutdown at 2.5-5 µA; connect to VS for always-ON; withstands 0-65 V, leakage 55-200 nA." }, { "number": "7", "name": "SLEEP", "type": "input",- "description": "Active-low SLEEP mode input; when low with EN high, disables charge pump and both gate drives, device draws 5.5-10 \u00b5A; internal bypass switch supports up to 100 mA peak to always-ON loads."+ "description": "Active-low SLEEP mode input; when low with EN high, disables charge pump and both gate drives, device draws 5.5-10 µA; internal bypass switch supports up to 100 mA peak to always-ON loads." }, { "number": "8",@@ -101,13 +101,13 @@ "number": "9", "name": "TMR", "type": "passive",- "description": "Fault timer node; capacitor from TMR to GND sets circuit-breaker turn-off delay (CTMR charged at 65-97 \u00b5A source, discharged at 2-3.15 \u00b5A sink) and auto-retry period; leave open for fastest response or tie to GND to disable OCP."+ "description": "Fault timer node; capacitor from TMR to GND sets circuit-breaker turn-off delay (CTMR charged at 65-97 µA source, discharged at 2-3.15 µA sink) and auto-retry period; leave open for fastest response or tie to GND to disable OCP." }, { "number": "10", "name": "IMON", "type": "output",- "description": "Analog current monitor output; sources scaled replica of sense voltage per VIMON = (RIMON/0.9) \u00d7 (VSENSE/RSET); accuracy \u00b112.5% at VSENSE = 20 mV; output range 0-5 V; leave floating if unused."+ "description": "Analog current monitor output; sources scaled replica of sense voltage per VIMON = (RIMON/0.9) × (VSENSE/RSET); accuracy ±12.5% at VSENSE = 20 mV; output range 0-5 V; leave floating if unused." }, { "number": "11",@@ -119,7 +119,7 @@ "number": "12", "name": "FLT", "type": "output",- "description": "Open-drain fault output; pulled low on UVLO, OV, OCP, or SCP events; pull-down resistance 11-60 \u03a9; withstands 0-65 V; leakage -100 to +400 nA; requires external pull-up resistor."+ "description": "Open-drain fault output; pulled low on UVLO, OV, OCP, or SCP events; pull-down resistance 11-60 Ω; withstands 0-65 V; leakage -100 to +400 nA; requires external pull-up resistor." }, { "number": "13",@@ -131,7 +131,7 @@ "number": "14", "name": "HGATE", "type": "output",- "description": "Load-disconnect MOSFET Q2 gate drive output; V(HGATE)-V(OUT) = 10-14.5 V for VS 5-65 V; source current 39-75 \u00b5A, sink current 128-180 mA during OV event; connect to GATE of external N-channel MOSFET."+ "description": "Load-disconnect MOSFET Q2 gate drive output; V(HGATE)-V(OUT) = 10-14.5 V for VS 5-65 V; source current 39-75 µA, sink current 128-180 mA during OV event; connect to GATE of external N-channel MOSFET." }, { "number": "15",@@ -155,7 +155,7 @@ "number": "18", "name": "ISCP", "type": "input",- "description": "Short-circuit protection threshold setting; leave floating to disable SCP; short to CS+ for 20 mV (typ) internal threshold; external series RISCP shifts threshold by 10.5 \u00b5A \u00d7 RISCP + 20 mV; bias current 9.5-12 \u00b5A."+ "description": "Short-circuit protection threshold setting; leave floating to disable SCP; short to CS+ for 20 mV (typ) internal threshold; external series RISCP shifts threshold by 10.5 µA × RISCP + 20 mV; bias current 9.5-12 µA." }, { "number": "19",@@ -167,7 +167,7 @@ "number": "20", "name": "CS+", "type": "input",- "description": "Current sense amplifier positive input; connect to positive terminal of external sense resistor RSNS; RSET (50-100 \u03a9) from CS+ to VS scales OCP threshold; differential range CS+ to CS- limited to -0.3 V to +0.3 V absolute maximum."+ "description": "Current sense amplifier positive input; connect to positive terminal of external sense resistor RSNS; RSET (50-100 Ω) from CS+ to VS scales OCP threshold; differential range CS+ to CS- limited to -0.3 V to +0.3 V absolute maximum." }, { "number": "21",@@ -179,7 +179,7 @@ "number": "22", "name": "VS", "type": "power_in",- "description": "IC power supply input; connect to common-drain midpoint of back-to-back MOSFET configuration; operating range 3-65 V; decouple with 100-nF capacitor to GND; quiescent current 630-750 \u00b5A (EN high, 12 V)."+ "description": "IC power supply input; connect to common-drain midpoint of back-to-back MOSFET configuration; operating range 3-65 V; decouple with 100-nF capacitor to GND; quiescent current 630-750 µA (EN high, 12 V)." }, { "number": "23",@@ -278,5 +278,8 @@ "docs/lm74900qrgerq1-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }