main
Ray lm51551qdsstq1: specified limits as data (metadata.characteristics, 60 rows from the datasheet) 81ad7f7

LM51551QDSSTQ1

Texas Instruments · DC-DC Converters · WSON-12-EP(2x3)

LM51551QDSSTQ1 from Texas Instruments, in a WSON-12-EP(2x3). Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin Name Type Function
1 BIAS power_in VCC regulator power supply voltage input (3.5V to 45V); connect bypass capacitor between this pin and PGND.
2 VCC power_out Internal VCC regulator output and MOSFET driver power supply voltage (6.85V typical); connect ceramic bypass capacitor to PGND.
3 GATE output N-channel MOSFET gate drive output (1.5A peak); connect via short low-inductance path directly to MOSFET gate.
4 PGND power_in Power ground pin; connect via wide short low-inductance path to current sense resistor ground connection.
5 CS input Current sense input pin; connect via short path to positive side of current sense resistor (100mV ±7% threshold).
6 COMP output Internal transconductance error amplifier output; connect loop compensation network (RCOMP, CCOMP) between this pin and PGND.
7 AGND power_in Analog ground pin; connect via wide short path to analog ground plane layer.
8 FB input Error amplifier inverting input; connect voltage divider from output to set 1.0V ±1% target voltage in boost/SEPIC topologies.
9 SS input Soft-start time programming pin; external capacitor and internal 10µA current source set soft-start ramp rate, ground to AGND.
10 RT input Switching frequency setting pin; program switching frequency from 100kHz to 2.2MHz via resistor between RT and AGND.
11 PGOOD output Power good indicator open-drain output; pulls low when FB below 87-93% of VREF, pull up to system voltage (max 1mA sink).
12 UVLO/SYNC input Undervoltage lockout and external clock sync input; connect via resistor divider to set startup/shutdown thresholds or apply sync pulses.
13 EP passive Exposed pad (from the footprint; not named in the datasheet pin table).

Key specifications

Parameter Value
Manufacturer Texas Instruments
Package WSON-12-EP(2x3)
Category Power Management (PMIC)
Pins 13

Electrical characteristics

Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).

Parameter Symbol Min Typ Max Unit Conditions Page
BIAS 至 AGND -0.3 50 V 5
UVLO 至 AGND -0.3 V 5
SS 至 AGND -0.3 3.8 V 5
RT 至 AGND -0.3 3.8 V 5
FB 到 AGND -0.3 3.8 V 5
CS 至 AGND(直流) -0.3 0.3 V 5
CS 至 AGND -1 V 100ns 瞬态 5
CS 至 AGND -2 V 20ns 瞬态 5
PGND 至 AGND -0.3 0.3 V 5
VCC 到 AGND -0.3 18 V 5
GATE 至 AGND -1 V 100ns 瞬态 5
GATE 至 AGND -2 V 50ns 瞬态 5
PGOOD 至 AGND -0.3 18 V 5
COMP 至 AGND -0.3 V 5
结温,TJ TJ -40 150 °C 5
贮存温度 Tstg -55 150 °C 5
VBIAS 偏置输入 VBIAS 2.97 45 V 6
VCC 电压 VVCC 2.97 16 V 6
UVLO 输入 VUVLO 0 45 V 6
FB 输入 VFB 0 3.7 V 6
典型开关频率 fSW 100 2200 kHz 6
同步脉冲频率 fSYNC 100 2200 kHz 6
工作结温 TJ -40 150 °C 6
BIAS 关断电流 ISHUTDOWN(BIAS) 2.6 5 uA VBIAS = 12V,VUVLO = 0V 6
BIAS 工作电流 IOPERATING(BIAS) 480 540 uA VBIAS = 12V,VUVLO = 2V,VFB = VREF,RT = 220kΩ 6
VCC 稳压(空载) VVCC-REG 6.5 6.85 7 V VBIAS = 8V,空载 6
VCC 稳压(带载) 6.5 V VBIAS = 8V,IVCC = 35mA 6
VCC UVLO 阈值 VVCC-UVLO(RISING) 2.75 2.85 2.95 V VCC 上升 6
VCC 拉电流限值 IVCC-CL 35 105 mA VBIAS = 10V,VVCC = 0V 6
启用阈值 VEN(RISING) 0.4 0.52 0.7 V EN 上升 7
启用阈值 VEN(FALLING) 0.33 0.49 0.63 V EN 下降 7
UVLO/SYNC 阈值 VUVLO(RISING) 1.425 1.5 1.575 V UVLO 上升 7
UVLO/SYNC 阈值 VUVLO(FALLING) 1.37 1.45 1.52 V UVLO 下降 7
UVLO 迟滞电流 IUVLO 4 5 6 uA VUVLO = 1.6V 7
软启动电流 ISS 9 10 11 uA 7
开关频率 fsw1 85 100 115 kHz RT = 220kΩ 7
开关频率 fsw2 1980 2200 2420 kHz RT = 9.09kΩ 7
最大占空比限制 DMAX1 80 85 90 % RT = 9.09kΩ 7
最大占空比限制 DMAX2 90 93 96 % RT = 220kΩ 7
峰值斜坡补偿电流 ISLOPE 22.5 30 37.5 uA RT = 220kΩ 7
电流限制阈值 (CS-PGND) VCLTH 93 100 107 mV 7
FB 基准 VREF 0.99 1 1.01 V LM5155、LM51551 7
COMP 钳位电压(上升) 2.5 2.8 V COMP 上升 (VUVLO = 2.0V) 7
COMP 钳位电压(下降) 1 1.1 V COMP 下降 7
欠压阈值 VUVTH 87 90 93 % FB 下降(参考 VREF) 7
VCC UVLO 迟滞 0.063 V VCC 下降 6
最短导通时间 tON(MIN) 50 ns RT = 9.09kΩ 7
误差放大器跨导 Gm 2 mA/V 7
COMP 拉电流 180 uA VCOMP = 1.2V 7
断续启用周期(LM51551) 64 周期 7
断续计时器复位周期(LM51551) 8 周期 7
热关断阈值 TTSD 175 °C 温度上升 7
高态电压降 0.25 V 100mA 灌电流 7
低态电压降 0.15 V 100mA 拉电流 7
结至环境热阻(DSS0012C WF) RθJA 60.3 °C/W 6
结至外壳(顶部)热阻(DSS0012C WF) RθJC(top) 60.1 °C/W 6
结至电路板热阻(DSS0012C WF) RθJB 28.8 °C/W 6
结至顶部特征参数(DSS0012C WF) ψJT 2 °C/W 6
结至电路板特征参数(DSS0012C WF) ψJB 28.7 °C/W 6
结至外壳(底部)热阻(DSS0012C WF) RθJC(bot) 7.1 °C/W 6

CAD (KiCad official)

  • Symbol: LM51551QDSSTQ1
  • Footprint: Package_SON:WSON-12-1EP_3x2mm_P0.5mm_EP1x2.65
  • 3D model: WSON-12-EP(2x3), generated from the KiCad footprint (body from the F.Fab outline, terminals on the pads, 0.75 mm nominal WSON height). Neither the vendor nor KiCad ships a 3D model for this package, so the dimensions are nominal, not the manufacturer's CAD (STEP)
  • 3D model files: lm51551qdsstq1-etched.step / lm51551qdsstq1-etched.glb carry the MPN laser-etched on the die in a toggleable Adom.LaserEtch group (Fusion-ready); lm51551qdsstq1.step / lm51551qdsstq1.glb are the bare package body.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

  • Datasheet: Texas Instruments datasheet (50 pp, sha256 a8503f9fa4bec785, retrieved 2026-10-01, tier: lcsc)
  • Datasheet language: Chinese. Pin names, descriptions, and specs on this page were extracted and translated to English by ds2sf; the linked PDF is the manufacturer original.
  • Extractor: parts-factory 2.0.0 / extract_pins 0.3, primary claude-haiku-4-5-20251001 (text), consensus claude-sonnet-5-5 (agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish.
  • CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF