by adom
A 12,960-LED addressable wall for the Adom workcell: 9 identical 160x160mm tiles (1,440 Dialight 587-1024-147F 2020 LEDs each, RP2040 + USB-C per tile) on a LrgLrg 576x576 scaffold. Remote Adom users each own a pixel.
← Commit history
A5: 6-layer stackup, MCU strip on the back face (front = pure LED canvas)
2 files changed
+26
docs/plan/DECISIONS.md+14@@ -69,3 +69,17 @@ uplinks to the control panel over USB-C. - Firmware: one UF2 for all tiles; role from straps. Master: USB CDC <-> I2C bridge. Bulk frames carry the tile address; sparse per-LED updates are the common case (full-tile frame ~110ms at 400kHz — art-rate, fine).++## Amendment 2026-09-29c — 6 layers, entire MCU strip on the BACK face+After the strip routing analysis proved the 14mm front strip could not carry the MCU+section at 0.2mm clearance, the whole MCU strip (RP2040, flash, crystal, LDO, shifter,+USB-C, straps, caps, I2C contacts) moved to the back face, and the board went 4L -> 6L+(F.Cu / In1 GND / In2 V5 / In3 GND / In4 GND / B.Cu). Wins:+- The front is a pure LED canvas — no strip band on camera; the grid reads fully+ contiguous across the 3x3 wall (the user's actual requirement).+- V3V3 and V1V1 become B.Cu zones that connect their pads directly (no stub vias).+- Strip signals escape the QFN with staggered fanout + an F.Cu river (front strip empty).+- Docking contacts MP1-4 move to the back too, which is how they mate scaffold pins+ (pins insert from below).+- 4 GND layers for the 20A LED return.+LED count is unchanged: 1424/tile (40x36 grid minus 16 docking cells), 12,816 for the wall.
docs/plan/GENERATOR-SPEC.md+12@@ -81,3 +81,15 @@ points. DRC decides; report the final scheme. ## A3. Scratch paths Probe/scratch boards go to gen/scratch/ — NEVER into run/ (reserved for the aiflow run).++## A4. Scaffold docking contacts (2026-09-29)+The tile docks to the base scaffold's 32mm large-contact grid (see docs/plan/SCAFFOLD.md):+- Add 4x MachineContactLarge at tile-local (32,32), (128,32), (32,128), (128,128) mm:+ refs MP1..MP4; MP1/MP4 = V5, MP2/MP3 = GND (diagonal pairs). Nets wired to the V5/GND+ planes with via rings around each contact pad (4x 0.6/0.3 vias per contact).+- OMIT the LED cell nearest each contact (4 omitted positions total): skip those grid+ points entirely — no footprint, no refs, chain numbering skips them (so 1436 LEDs:+ redistribute chain membership so each chain still serpentines its rows; document the+ final per-chain counts). Update moves.json/route-plan.json accordingly.+- Keepout: no tracks/rails/vias within 2.6mm of a contact center except its own nets'+ ring vias; the contact's Ø4.40 ring + pincer clearance needs it.