component
47L04-I
Public Made by Adomby adom
Microchip Tech Pre-ordered MCUs, SOIC-8. Pinout cross-checked by two models against the datasheet, KiCad symbol/footprint/3D.
3D Model
Open in new tab ↗
Loads when you scroll to it. Unloads after 5 minutes in the background.
Symbol & Footprint
Schematic Symbol
Open full view ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
PCB Footprint
Open full view ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
Datasheet
Open in new tab ↗Loads when you scroll to it. Unloads after 5 minutes in the background.
Contents
README
markdown47L04-I
Microchip Tech · Pre-ordered MCUs · SOIC-8
47L04-I from Microchip Tech, in a SOIC-8. Pinout and pin descriptions extracted from the manufacturer datasheet (extract_pins, cross-checked by a second model); symbol, footprint, and 3D from KiCad-official CAD.
Pinout
| Pin | Name | Type | Function |
|---|---|---|---|
| 1 | VCAP | passive | Capacitor input connected to the internal power bus; connect a CVCAP capacitor for Auto-Store, or tie to VCC (with Auto-Store disabled via ASE bit = 0) if no capacitor is used. |
| 2 | A1 | input | Chip address select input compared with client address Chip Select bits for up to four devices on one bus; internally pulled down to VSS if left unconnected. |
| 3 | A2 | input | Chip address select input compared with client address Chip Select bits for up to four devices on one bus; internally pulled down to VSS if left unconnected. |
| 4 | VSS | power_in | Ground. |
| 5 | SDA | bidirectional | Open-drain serial data pin for addresses and data, requiring a pull-up resistor to VCC (typical 10 kΩ for 100 kHz, 2 kΩ for 400 kHz and 1 MHz). |
| 6 | SCL | input | Serial clock input used to synchronize data transfer to and from the device. |
| 7 | HS | input | Hardware Store/Event Detect input that initiates a Hardware Store when driven high for THSPW time and sets the EVENT bit; internally pulled down to VSS if left unconnected. |
| 8 | VCC | power_in | Power supply; 2.7V-3.6V range for the 47L04. |
Key specifications
| Parameter | Value |
|---|---|
| Manufacturer | Microchip Tech |
| Package | SOIC-8 |
| Category | Embedded Processors & Controllers |
| Pins | 8 |
Electrical characteristics
Limits as printed in the datasheet (page.json metadata.characteristics carries them as data).
| Parameter | Symbol | Min | Typ | Max | Unit | Conditions | Page |
|---|---|---|---|---|---|---|---|
| Supply voltage | VCC | 6.5 | V | 3 | |||
| Pin voltage w.r.t. VSS | -0.6 | 6.5 | V | A1, A2, SDA, SCL, HS pins | 3 | ||
| Storage temperature | -65 | 150 | °C | 3 | |||
| Ambient temperature under bias | -40 | 125 | °C | 3 | |||
| ESD protection on all pins | 4 | kV | ≥4 kV | 3 | |||
| Supply voltage range | VCC | 2.7 | 3.6 | V | 47LXX | 3 | |
| Operating temperature (Industrial) | TA | -40 | 85 | °C | Industrial (I) | 3 | |
| Low-Level Input Voltage | VIL | -0.3 | V | max is 0.3VCC | 3 | ||
| Low-Level Output Voltage | VOL | 0.4 | V | IOL = 3.0 mA | 3 | ||
| Input Leakage Current (SDA, SCL) | ILI | -1 | 1 | µA | VIN = VSS or VCC | 3 | |
| Output Leakage Current (SDA) | ILO | -1 | 1 | µA | VOUT = VSS or VCC | 3 | |
| Input Resistance to VSS (A1, A2, HS) | RIN | 50 | kΩ | VIN = VIL (maximum) | 3 | ||
| Input Resistance to VSS (A1, A2, HS) | RIN | 750 | kΩ | VIN = VIH (minimum) | 3 | ||
| Internal Capacitance (all inputs and outputs) | CINT | 7 | pF | TA = +25°C, FREQ = 1 MHz, VCC = 5.5V (Note 1) | 3 | ||
| Active Operating Current | ICC | 150 | 300 | µA | VCC = 3.6V, FCLK = 1 MHZ | 3 | |
| Recall Current | ICC Recall | 300 | 500 | µA | VCC = 3.6V (Note 2) | 3 | |
| Manual Store Current | ICC Store | 1500 | µA | VCC = 3.6V (Note 2) | 3 | ||
| Auto-Store Current | ICC Auto-Store | 300 | µA | VCC, VCAP = VTRIP (minimum) 47LXX (Note 1, Note 2 and Note 3) | 4 | ||
| Status Write Current | ICC Status Write | 1500 | µA | VCC = 3.6V | 4 | ||
| Standby Current | ICCS | 40 | µA | SCL, SDA, VCAP, VCC = 3.6V | 4 | ||
| Auto-Store/Auto-Recall Trip Voltage | VTRIP | 2.4 | 2.6 | V | 47LXX | 4 | |
| Power-On Reset Voltage | VPOR | 1.1 | V | 4 | |||
| Bus Capacitance | CB | 400 | pF | 4 | |||
| Auto-Store Capacitance | CVCAP | 5 | 6.8 | µF | 47L04 (Note 1 and Note 3) | 4 | |
| Clock Frequency | FCLK | 1000 | kHz | 5 | |||
| Clock High Time | THIGH | 500 | ns | 5 | |||
| Clock Low Time | TLOW | 500 | ns | 5 | |||
| SDA and SCL Input Rise Time | TR | 300 | ns | Note 1 | 5 | ||
| SDA and SCL Input Fall Time | TF | 300 | ns | Note 1 | 5 | ||
| Start Condition Hold Time | THD:STA | 250 | ns | 5 | |||
| Start Condition Setup Time | TSU:STA | 250 | ns | 5 | |||
| Data Input Hold Time | THD:DAT | 0 | ns | 5 | |||
| Data Input Setup Time | TSU:DAT | 100 | ns | 5 | |||
| Stop Condition Setup Time | TSU:STO | 250 | ns | 5 | |||
| Output Valid from Clock | TAA | 400 | ns | 5 | |||
| Bus Free Time | TBUF | 500 | ns | Bus time must be free before a new transmission can start | 5 | ||
| Input Filter Spike Suppression (SDA, SCL and HS pins) | TSP | 50 | ns | Note 1 | 5 | ||
| Hardware Store Pulse Width | THSPW | 150 | ns | 5 | |||
| Recall Operation Duration | TRECALL | 2 | ms | 47X04 | 5 | ||
| Store Operation Duration | TSTORE | 8 | ms | 47X04 | 5 | ||
| STATUS Register Write Cycle Time | TWC | 1 | ms | 5 | |||
| VCC Rise Rate | TVRISE | 70 | µs/V | Note 1 | 5 | ||
| VCC Fall Rate | TvFALL | 70 | µs/V | Note 1 | 5 | ||
| EEPROM Endurance | 1e+06 | Store cycles | +25°C, VCC = 5.5V (Note 1 and Note 2) | 5 |
Materials and finish
As the datasheet states them (page.json metadata.appearance; the 3D model's colours follow it).
| Part | Material | Colour / plating | Datasheet says | Page |
|---|---|---|---|---|
| contacts | tin | 8-Lead Plastic Small Outline (SN) - Narrow, 3.90 mm (.150 In.) Body [SOIC] A A2 | 30 |
CAD (KiCad official)
- Symbol:
47L04-I - Footprint:
Package_SO:SOIC-8_3.9x4.9mm_P1.27mm - 3D model: SOIC-8 (KiCad packages3D, STEP)
- 3D model files:
47l04-i-etched.step/47l04-i-etched.glbcarry the MPN laser-etched on the die in a toggleableAdom.LaserEtchgroup (Fusion-ready);47l04-i.step/47l04-i.glbare the bare package body.
Provenance
Data extracted from the manufacturer datasheet, not a distributor listing:
- Datasheet: Microchip Tech datasheet (41 pp, sha256
116d347ebafd9830, retrieved 2026-10-23, tier: manufacturer) - Extractor: parts-factory
2.0.0/extract_pins 0.3, primaryclaude-sonnet-5-5(text), consensusclaude-sonnet-5-5(agreed), guards: pin_guards 0.1: passed. Pins are checked against the footprint pad set and their cited datasheet pages before publish. - CAD: KiCad official libraries (CC-BY-SA 4.0).