M24M02-DRMN6TP from STMicroelectronics, in a SOIC-8. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin	Name	Type	Function
1	DU	unconnected	Do not use. No signal should be applied on this pin; if connected, it must be tied to VSS.
2	DU	unconnected	Do not use. No signal should be applied on this pin; if connected, it must be tied to VSS.
3	E2	input	Chip Enable address input. Sets the value looked for on bit b3 of the 7-bit I2C device select code. Must be tied to VCC or VSS; if left floating it is read as low (0).
4	VSS	power_in	Ground reference for the VCC supply voltage.
5	SDA	bidirectional	Serial Data I/O for the I2C bus. SDA(out) is an open-drain output that may be wire-OR'ed with other open-drain/open-collector signals on the bus; an external pull-up resistor to VCC is required.
6	SCL	input	Serial Clock input for the I2C bus. Strobes data on SDA(in) and clocks data out on SDA(out). Supports 100 kHz, 400 kHz and 1 MHz operation.
7	WC	input	Write Control (active-low, /WC). When driven high, all write operations to the memory array are inhibited (device-select and address bytes are still ACK'd, data bytes are not). When driven low or left floating, writes are enabled.
8	VCC	power_in	Supply voltage input. Operating range 1.8 V to 5.5 V over -40 to +85 C. Decouple with a 10 nF to 100 nF capacitor close to the VCC/VSS pins.

Key specifications

Parameter	Value
Manufacturer	STMicroelectronics
Package	SOIC-8
Category	Memory
Pins	8

Ordering variants

Same part, different packaging or reel option.

M24M02-DRMN6TP
M24M02-DRMN6TPCS6T
M24M02-DRMN6TPW6T

CAD (KiCad official)

Symbol: M24M02-DRMN6TP
Footprint: Package_SO:SOIC-8_3.9x4.9mm_P1.27mm
3D model: SOIC-8 (KiCad packages3D, STEP)

3D model downloads

Two STEP files. Same geometry, different body top:

File	Size	Use it when
`m24m02-drmn6tp.step`	122 KB	You want the bare part, or you mark your own boards.
`m24m02-drmn6tp-etched.step`	2.4 MB	You want the part with `M24M02-DRMN6TP` already on it.

The marking in the etched file is real recessed geometry cut into the solid, not a texture or a decal: 620 faces against 147 in the bare model. It survives export, section views, and rendering in any CAD tool, and it drops straight into KiCad or Fusion with no extra setup.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

Datasheet: STMicroelectronics datasheet (40 pp, sha256 1da05aeb020e6185, retrieved 2026-08-17, tier: manufacturer)
Extractor: ds2sf (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.
CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF