ADA4692-2ARZ from UMW, in a SOP-8. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.

Pinout

Pin	Name	Type	Function
1	OUTA	output	Output of amplifier A. Rail-to-rail output; drives loads down to 600 ohm with typical VOH ~2.67 V and VOL ~24 mV at Vsy=2.7 V, RL=2 kohm.
2	-INA	input	Inverting input of amplifier A. Very high impedance CMOS input with typical 0.5 pA bias current; input voltage range -0.3 V to (V+)-1.1 V (per common-mode conditions in electrical tables).
3	+INA	input	Non-inverting input of amplifier A. High-impedance CMOS input, typical Ib = 0.5 pA, typical Ios = 1 pA; supports common-mode voltage down to 0.3 V below V-.
4	V-	power_in	Negative supply / ground. Tie to GND for single-supply operation (2.7 V-5 V) or to -Vsy for split supplies (+/-1.35 V to +/-2.5 V). Absolute maximum supply-to-supply voltage is 6 V.
5	+INB	input	Non-inverting input of amplifier B. Same characteristics as +INA: pA-level bias current, rail-to-rail-ish input range extending 0.3 V below V-.
6	-INB	input	Inverting input of amplifier B. High-impedance CMOS input identical to -INA.
7	OUTB	output	Output of amplifier B. Rail-to-rail output stage identical to OUTA; short-circuit current typical +/-15 mA at Vsy=2.7 V (+/-55 mA at 5 V).
8	V+	power_in	Positive supply pin. Operating range 2.7 V to 5.5 V (single supply, V- = GND) or up to +2.5 V for split-supply operation. Typical supply current 180 uA per amplifier at 5 V.

Key specifications

Parameter	Value
Manufacturer	UMW
Package	SOP-8
Category	Op-amp/Cmp
Pins	8

Ordering variants

ADA4692-2ARZ
ADA4692-2ARZRU-14

CAD (KiCad official)

Symbol: ADA4692-2ARZ
Footprint: Package_SO:SOIC-8_3.9x4.9mm_P1.27mm
3D model: SOP-8 (KiCad packages3D, STEP)

3D model downloads

Two STEP files. Same geometry, different body top:

File	Size	Use it when
`ada4692-2arz.step`	122 KB	You want the bare part, or you mark your own boards.
`ada4692-2arz-etched.step`	2.2 MB	You want the part with `ADA4692-2ARZ` already on it.

The marking in the etched file is real recessed geometry cut into the solid, not a texture or a decal: 555 faces against 147 in the bare model. It survives export, section views, and rendering in any CAD tool, and it drops straight into KiCad or Fusion with no extra setup.

Provenance

Data extracted from the manufacturer datasheet, not a distributor listing:

Datasheet: UMW datasheet (20 pp, sha256 aee95e44814abb06, retrieved 2026-08-17, tier: lcsc)
Extractor: ds2sf (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.
CAD: KiCad official libraries (CC-BY-SA 4.0).

Datasheet PDF