# Control Panel Mpin Connector

An Adom modular **board-to-board connector strip** (175 x 10 mm) that carries power and signals
across the Adom machine-pin stack. Press-fit **machine pins** stand vertical along the strip and
mate with machine contacts on the adjacent board.

## The 3D model above has BAKED SILKSCREEN

This page demonstrates the full **Fusion 360 to wiki-grade 3D** pipeline end to end, including the
silkscreen bake. The interactive model above is the real board with its silkscreen composited onto
the soldermask: **SIDE A**, the **GND** / **5V** rails, the RUD signal labels, and every refdes,
exactly where they sit on the physical board. Drag to orbit, scroll to zoom.

How it was made (all reproducible):

1. Opened the Fusion electronics design, exported the **STEP** (3D) and the **gerbers** (2D board).
2. Rendered the top/bottom **Legend** gerber layers to PNGs framed exactly to the board outline
   (`Profile` layer, 175 x 10 mm), so the silk registers 1:1 with the board.
3. Ran STEP + the two silk PNGs through **service-step2glb molecule mode**: OCCT tessellation ->
   anchor to the machine pins -> **silkscreen bake** -> gold pins -> join/weld/prune -> Draco.

Result: a **196 KB, 6-mesh** GLB with baked silkscreen, auto-anchored. Same optimizer that produces
the gorgeous molecule 3D models across the wiki.

## Board

| Property | Value |
|---|---|
| Outline | 175 x 10 mm |
| Machine pins | 8 (press-fit) |
| Silkscreen | baked into the 3D model |
| Source | Fusion 360 electronics design (Main project) |

## Related
- [Machine Pin Medium Standard](https://wiki.adom.inc/adom/machinepinmediumstandard) - the press-fit pin used here.