Open general

Symbol pins are unpolarised: pad 1 = negative, pad 2 = positive (per Amass drawing)

FalconFour ·

The symbol on this page names its pins "1" and "2", so nothing on the page says which pad is positive. XT30 is a polarised power connector, so a reversed guess puts reverse voltage on a board.

Polarity, from the Amass XT30PW-F spec sheet (V1.2) drawing, checked against a physical XT30 connector:

  • XT30 housing rule: the square (flat) end of the housing is positive, the chamfered end is negative.
  • In the spec sheet's face view, the chamfered (negative) contact is the lower one. Carried over to the mounting-hole view (安装孔示意图, pegs above the contact holes), the negative contact is the LEFT Ø1.7 hole.
  • This page's footprint has the same orientation as that view (pegs at y = -2.5, contacts at y = +2.5, pad 1 at x = -2.5), so: pad 1 = negative (-), pad 2 = positive (+).
  • KiCad's stock footprint Connector_AMASS:AMASS_XT30PW-F_1x02_P2.50mm_Horizontal agrees: its silkscreen has "-" beside pad 1 and "+" beside pad 2.

Suggested change: name the symbol pins "-" (pin 1) and "+" (pin 2), and add "+" / "-" marks on the footprint silkscreen or fab layer beside the pads, as the KiCad stock footprint does.

Related: there is no page yet for the male part XT30PW-M30.G.Y (LCSC C431092). By mating geometry and KiCad's stock footprint its pad 1 is also negative and pad 2 positive; that one has not been checked against a physical part.

0 Replies

Log in to reply.