component
UTC2000T-I
Public Made by Adomby adom
Microchip Tech Power Management - Specialized, QFN-16-EP(3x3). Pinout extracted from the datasheet, KiCad symbol/footprint/3D.
← Commit history
page.json+8−5@@ -32,7 +32,7 @@ "number": "1", "name": "OCS#", "type": "input",- "description": "Active-low fault input (Schmitt-triggered, internal ~100 \u00b5A pull-up). Asserted by the +5V VBUS power-supply device to notify the UTC2000 of a system fault (typically overcurrent/overvoltage). All digital control outputs revert to their default deasserted state while OCS# is asserted, and FAULT_IND latches high until reset/power cycle."+ "description": "Active-low fault input (Schmitt-triggered, internal ~100 µA pull-up). Asserted by the +5V VBUS power-supply device to notify the UTC2000 of a system fault (typically overcurrent/overvoltage). All digital control outputs revert to their default deasserted state while OCS# is asserted, and FAULT_IND latches high until reset/power cycle." }, { "number": "2",@@ -44,7 +44,7 @@ "number": "3", "name": "ENABLE", "type": "input",- "description": "Active-high controller enable (Schmitt-triggered digital input). When low, the UTC2000 remains in the Disabled Idle state with default deasserted outputs. If unused, tie to VDD through a 10 k\u03a9 pull-up resistor."+ "description": "Active-high controller enable (Schmitt-triggered digital input). When low, the UTC2000 remains in the Disabled Idle state with default deasserted outputs. If unused, tie to VDD through a 10 kΩ pull-up resistor." }, { "number": "4",@@ -98,7 +98,7 @@ "number": "12", "name": "VMON", "type": "input",- "description": "VBUS voltage-monitor ADC input. Monitors the USB receptacle VBUS (via an external resistor divider). If VMON exceeds 0.8 V (corresponding to >6.4 V on VBUS), the device enters the fault state and deasserts all outputs. Required in UFP modes; in DFP modes, if unused, tie to GND through a 10 k\u03a9 pull-down resistor."+ "description": "VBUS voltage-monitor ADC input. Monitors the USB receptacle VBUS (via an external resistor divider). If VMON exceeds 0.8 V (corresponding to >6.4 V on VBUS), the device enters the fault state and deasserts all outputs. Required in UFP modes; in DFP modes, if unused, tie to GND through a 10 kΩ pull-down resistor." }, { "number": "13",@@ -122,7 +122,7 @@ "number": "16", "name": "VDD", "type": "power_in",- "description": "5.0 V power input (operating range 4.5 V to 5.5 V). A minimum of one 0.1 \u00b5F bypass capacitor placed close to the pin is recommended. The high level of all digital outputs is referenced to VDD."+ "description": "5.0 V power input (operating range 4.5 V to 5.5 V). A minimum of one 0.1 µF bypass capacitor placed close to the pin is recommended. The high level of all digital outputs is referenced to VDD." }, { "number": "17",@@ -202,5 +202,8 @@ "docs/utc2000t-i-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }