← Commit history
README.mdadded+52@@ -0,0 +1,52 @@+# SG3525-HXY++**HXY MOSFET** · AC-DC Controllers and Regulators · SOP-16++SG3525-HXY from HXY MOSFET, in a SOP-16. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.++## Pinout++| Pin | Name | Type | Function |+|---|---|---|---|+| 1 | Inv. Input | input | Inverting input of the internal error amplifier. Common-mode range includes the 5.1 V reference so no external divider is required when regulating to VREF. |+| 2 | Noninv. Input | input | Non-inverting input of the internal error amplifier. Typical input offset 1.5 mV, bias current 1 µA, CMRR 90 dB. |+| 3 | Sync | bidirectional | Oscillator sync input/output for master/slave operation or synchronization with an external clock. Sync threshold typ 2 V; sync input current typ 1.3 mA at 3.5 V. |+| 4 | OSC. Output | output | Oscillator clock output. Provides the internal clock signal (typ 3 V amplitude, 0.6 µs width) for external use or scope monitoring. |+| 5 | CT | passive | Oscillator timing capacitor. Combined with RT (pin 6) sets the switching frequency (100 Hz-500 kHz range). Typical charging current 50 µA. |+| 6 | RT | passive | Oscillator timing resistor. Sets the oscillator charge current; typical range 2 kΩ (430 kHz) to 200 kΩ (60 Hz-120 Hz) with the corresponding CT. |+| 7 | Discharge | passive | Deadtime/discharge pin. A resistor between CT (pin 5) and Discharge sets the oscillator discharge time, which controls the deadtime between the A and B outputs. |+| 8 | Soft-Start | passive | Soft-start capacitor pin. An internal 50 µA current source charges the external capacitor to ramp up the duty cycle at startup. Typical soft-start current 51 µA. |+| 9 | Compensation | output | Error amplifier output and PWM comparator input. Loop compensation network (typically a resistor and capacitor to Inv. Input) is connected here. |+| 10 | Shutdown | input | Active-high shutdown input. Threshold typ 0.8 V (min 0.6 V, max 1 V). Asserting shutdown initiates the pulse-by-pulse latch-off, discharges the soft-start capacitor, and disables both outputs. |+| 11 | Output A | output | Push-pull totem-pole gate driver output A. Sources/sinks >200 mA (500 mA absolute max). Alternates with Output B; typ rise/fall 80 ns / 70 ns into 1 nF. |+| 12 | Ground | power_in | Signal and power ground return for the device. |+| 13 | VC | power_in | Collector supply for the output driver stage. Rated 40 V absolute maximum; usually tied to VCC but can be biased separately to drive gates from a different rail. |+| 14 | Output B | output | Push-pull totem-pole gate driver output B. Complementary phase to Output A for push-pull / half-bridge / full-bridge topologies. Same drive spec as Output A. |+| 15 | VCC | power_in | Main supply input. Operating range 8-35 V; 40 V absolute maximum. UVLO turns the device on around 7 V typical (6-8 V) with hysteresis. Typical ICC 12 mA. |+| 16 | Vref | power_out | 5.1 V ±1% precision reference output. Short-circuit current typ 80 mA (limit 100 mA); intended for biasing external circuitry, decouple with ~0.1 µF to ground. |++## Key specifications++| Parameter | Value |+|---|---|+| Manufacturer | HXY MOSFET |+| Package | SOP-16 |+| Category | PMIC |+| Pins | 16 |++## CAD (KiCad official)++- Symbol: `SG3525-HXY`+- Footprint: `Package_SO:SOIC-16_3.9x9.9mm_P1.27mm`+- 3D model: SOP-16 (KiCad packages3D, STEP)++## Provenance++Data extracted from the manufacturer datasheet, not a distributor listing:++- **Datasheet:** [HXY MOSFET datasheet](docs/sg3525-hxy-datasheet.pdf) (7 pp, sha256 `523bdd7216fb17e2`, retrieved 2026-08-17, tier: lcsc)+- **Datasheet language:** Chinese. Pin names, descriptions, and specs on this page were extracted and translated to English by ds2sf; the linked PDF is the manufacturer original.+- **Extractor:** `ds2sf` (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.+- **CAD:** KiCad official libraries (CC-BY-SA 4.0).++[Datasheet PDF](docs/sg3525-hxy-datasheet.pdf)
page.jsonadded+34@@ -0,0 +1,34 @@+{+ "slug": "sg3525-hxy",+ "version": "0.1.0",+ "type": "component",+ "description": "HXY MOSFET AC-DC Controllers and Regulators, SOP-16. Datasheet-verified pinout, KiCad symbol/footprint/3D.",+ "tags": [+ "component",+ "pmic",+ "sg3525-hxy"+ ],+ "dependencies": {},+ "hero": {+ "type": "image",+ "path": "docs/hero.png"+ },+ "files": [+ "page.json",+ "README.md",+ "sg3525-hxy.kicad_sym",+ "sg3525-hxy.kicad_mod",+ "sg3525-hxy.glb",+ "sg3525-hxy.step",+ "sg3525-hxy.lbr",+ "docs/hero.png",+ "docs/sg3525-hxy-datasheet.pdf",+ "viewers/symbol.html",+ "viewers/footprint.html"+ ],+ "visibility": "public",+ "author": {+ "name": "Ray",+ "email": "[email protected]"+ }+}