← Commit history
page.json+9−6@@ -32,13 +32,13 @@ "number": "1", "name": "RFIN", "type": "input",- "description": "RF input. AC-coupled internally via an on-chip 5pF capacitor in series with a ~2k\u03a9 resistance (highpass corner ~16MHz). Requires an off-chip 50\u03a9 impedance match."+ "description": "RF input. AC-coupled internally via an on-chip 5pF capacitor in series with a ~2kΩ resistance (highpass corner ~16MHz). Requires an off-chip 50Ω impedance match." }, { "number": "2", "name": "SHDN", "type": "input",- "description": "Active-low shutdown input. A logic LOW on SHDN shuts down the entire IC (typ. 13\u00b5A shutdown current). Logic thresholds: VIH \u2265 1.8V, VIL \u2264 0.8V."+ "description": "Active-low shutdown input. A logic LOW on SHDN shuts down the entire IC (typ. 13µA shutdown current). Logic thresholds: VIH ≥ 1.8V, VIL ≤ 0.8V." }, { "number": "3",@@ -50,7 +50,7 @@ "number": "4", "name": "CLPF", "type": "passive",- "description": "Lowpass filter connection. Connect an external capacitor between CLPF and GND to set the control-loop bandwidth (e.g. 150pF \u2192 ~8MHz small-signal bandwidth). A series resistor with CLPF may be added to introduce a zero for loop-dynamics compensation."+ "description": "Lowpass filter connection. Connect an external capacitor between CLPF and GND to set the control-loop bandwidth (e.g. 150pF → ~8MHz small-signal bandwidth). A series resistor with CLPF may be added to introduce a zero for loop-dynamics compensation." }, { "number": "5",@@ -62,13 +62,13 @@ "number": "6", "name": "N.C.", "type": "unconnected",- "description": "No connection. Leave unconnected or tie to GND. (Not bonded on \u03bcMAX; the UCSP variant omits this pin entirely.)"+ "description": "No connection. Leave unconnected or tie to GND. (Not bonded on μMAX; the UCSP variant omits this pin entirely.)" }, { "number": "7", "name": "OUT", "type": "output",- "description": "Detector output. Buffered log-detector voltage (~0.36V at -45dBm to ~1.45V at 0dBm RFIN into 50\u03a9; log slope \u2248 25.5mV/dB at 100MHz). Drive directly into a baseband ADC. Held near GND for ~5\u00b5s after power-up to avoid glitches."+ "description": "Detector output. Buffered log-detector voltage (~0.36V at -45dBm to ~1.45V at 0dBm RFIN into 50Ω; log slope ≈ 25.5mV/dB at 100MHz). Drive directly into a baseband ADC. Held near GND for ~5µs after power-up to avoid glitches." }, { "number": "8",@@ -152,5 +152,8 @@ "docs/max4003eua-t-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }