← Commit history
README.mdadded+59@@ -0,0 +1,59 @@+# M54133AG-S16-R++**UTC Unisonic Tech** · Supervisor and Reset ICs · SOP-16++M54133AG-S16-R from UTC Unisonic Tech, in a SOP-16. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.++## Pinout++| Pin | Name | Type | Function |+|---|---|---|---|+| 1 | GND | power_in | Ground reference for the device. |+| 2 | IREF | passive | Pin for connecting an external resistor (approx. 180 kΩ typical) that sets the constant current for internal circuits. Voltage at this pin is approximately 1.3 V. |+| 3 | VCC | power_out | Output of the internal constant-voltage regulator (~5.2 V at IOH=-1 mA). Requires an external decoupling capacitor to GND. |+| 4 | OFFC | passive | Reset-time capacitor pin. Connect a capacitor (e.g. 0.33 μF for TW3≈75 ms) that determines the restore time after a leakage event ends or after the SCR is triggered. Threshold ~2.4 V. |+| 5 | TRC1 | passive | Capacitor pin for the 3-ms integrator that integrates the signal output from the leak-signal input-level discriminator. Threshold ~2.4 V; typical C=0.01 μF for TW1≈3 ms. |+| 6 | TRC2 | passive | Capacitor pin for the 1-ms noise-elimination integrator. Threshold ~2.4 V; typical C=0.0047 μF for TW2≈1.5 ms. |+| 7 | DLYC | passive | Delay-timer capacitor pin. Connect a capacitor (e.g. 1.0 μF for TW4≈300 ms) to set the delay time when using the delay function. Threshold ~2.4 V. |+| 8 | SCRT | output | SCR gate driver output. Sources high output current (IOH ~-50 μA typ. at TA=+20 °C, VO=8 V) to trigger the external SCR that fires the trip coil; low output voltage VOL≈0.1 V at IOL=200 μA. |+| 9 | VREF | output | Reference-voltage output providing the input reference level for leakage detection. Nominal 2.4 V at IOH=-200 μA; VREF-to-GND clamp voltage 4.7 V at 5 mA. |+| 10 | ILKI | input | Leakage-detection signal input (the other side of the differential leakage detector, referenced to VREF). DC input voltage of leakage detection ±14.0 mVdc w.r.t. VREF; total AC input VT=11.5 mVrms typ. at 60 Hz; input bias current ~220 nA. |+| 11 | OPAO | output | Output of the internal operational amplifier used as an active low-pass filter. IOH=2.8 mA, IOL=0.8 mA; max output swing 3.5 Vpp; voltage gain 40 dB at 1 kHz; -3 dB BW=6 kHz. |+| 12 | C2 | passive | Compensation capacitor pin for the op-amp; connect a capacitor between pins 11 (OPAO) and 12 to prevent abnormal oscillations. |+| 13 | OPI- | input | Inverting (negative) input of the internal operational amplifier. Differential input clamp ±0.8 V; differential input current limit ±5 mA; input bias current ~125 nA. |+| 14 | C1 | passive | Noise-filter capacitor pin for the op-amp inputs; connect capacitors between pin 14 and pin 13 (OPI-) and between pin 14 and pin 15 (OPI+) to prevent noise-induced malfunction. |+| 15 | OPI+ | input | Non-inverting (positive) input of the internal operational amplifier. Differential input clamp ±0.8 V vs. OPI-; input bias current ~125 nA. |+| 16 | VS | power_in | Main power supply input. Recommended operating range 7-12 V; absolute maximum 15 V. Standby supply current IS0=610 μA typ. at RIREF=180 kΩ. |++## Key specifications++| Parameter | Value |+|---|---|+| Manufacturer | UTC Unisonic Tech |+| Package | SOP-16 |+| Category | PMIC |+| Pins | 16 |++## Ordering variants++Same part, different packaging or reel option.++- `M54133AG-S16-R`+- `M54133AL-S16N-R`+- `M54133AG-S16N-R`++## CAD (KiCad official)++- Symbol: `M54133AG-S16-R`+- Footprint: `Package_SO:SOIC-16_3.9x9.9mm_P1.27mm`+- 3D model: SOP-16 (KiCad packages3D, STEP)++## Provenance++Data extracted from the manufacturer datasheet, not a distributor listing:++- **Datasheet:** [UTC Unisonic Tech datasheet](docs/m54133ag-s16-r-datasheet.pdf) (7 pp, sha256 `3837fabbf92a63da`, retrieved 2026-08-17, tier: manufacturer)+- **Extractor:** `ds2sf` (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.+- **CAD:** KiCad official libraries (CC-BY-SA 4.0).++[Datasheet PDF](docs/m54133ag-s16-r-datasheet.pdf)
page.jsonadded+34@@ -0,0 +1,34 @@+{+ "slug": "m54133ag-s16-r",+ "version": "0.1.0",+ "type": "component",+ "description": "UTC Unisonic Tech Supervisor and Reset ICs, SOP-16. Datasheet-verified pinout, KiCad symbol/footprint/3D.",+ "tags": [+ "component",+ "pmic",+ "m54133ag-s16-r"+ ],+ "dependencies": {},+ "hero": {+ "type": "image",+ "path": "docs/hero.png"+ },+ "files": [+ "page.json",+ "README.md",+ "m54133ag-s16-r.kicad_sym",+ "m54133ag-s16-r.kicad_mod",+ "m54133ag-s16-r.glb",+ "m54133ag-s16-r.step",+ "m54133ag-s16-r.lbr",+ "docs/hero.png",+ "docs/m54133ag-s16-r-datasheet.pdf",+ "viewers/symbol.html",+ "viewers/footprint.html"+ ],+ "visibility": "public",+ "author": {+ "name": "Ray",+ "email": "[email protected]"+ }+}