← Commit history
lmc555m: restore the component block (pinout + model declarations) from this page's own README and symbol
1 file changed
+74−1
page.json+74−1@@ -33,5 +33,78 @@ "author": { "name": "Ray", "email": "[email protected]"+ },+ "component": {+ "mpn": "LMC555M",+ "manufacturer": "HGSEMI",+ "package": "SOP-8",+ "pin_count": 8,+ "category": "Timers / Clock Oscillators",+ "parts": {+ "symbol": "lmc555m.kicad_sym",+ "footprint": "lmc555m.kicad_mod",+ "model_3d": "lmc555m-etched.glb",+ "model_3d_plain": "lmc555m.glb",+ "model_3d_step": "lmc555m-etched.step",+ "model_3d_step_plain": "lmc555m.step",+ "lbr": "lmc555m.lbr"+ },+ "pins": [+ {+ "number": "1",+ "name": "GND",+ "type": "power_in",+ "description": "Ground reference (0V). Connect to the negative supply rail."+ },+ {+ "number": "2",+ "name": "TRIGGER",+ "type": "input",+ "description": "Trigger input. When the voltage at this pin falls below 1/3 VCC, the internal flip-flop is set and the OUTPUT goes HIGH. High input impedance CMOS input."+ },+ {+ "number": "3",+ "name": "OUTPUT",+ "type": "output",+ "description": "Push-pull CMOS output. Can source and sink current to drive TTL/CMOS loads. Output swings between GND and VCC."+ },+ {+ "number": "4",+ "name": "RESET",+ "type": "input",+ "description": "Active-low reset input. When held below approximately 0.7V, forces the OUTPUT LOW and DISCHARGE ON regardless of other inputs. Tie to VCC when not used."+ },+ {+ "number": "5",+ "name": "CONTROL",+ "type": "input",+ "description": "Control voltage input. Provides direct access to the internal 2/3 VCC threshold reference divider. Typically bypassed to GND with a 0.01µF capacitor when not used."+ },+ {+ "number": "6",+ "name": "THRESHOLD",+ "type": "input",+ "description": "Threshold input. When the voltage at this pin rises above 2/3 VCC (or the CONTROL voltage), the internal flip-flop is reset and the OUTPUT goes LOW. High input impedance CMOS input."+ },+ {+ "number": "7",+ "name": "DISCHARGE",+ "type": "output",+ "description": "Open-drain discharge output. Connected to GND internally through an N-channel MOSFET when the internal flip-flop is reset (OUTPUT LOW). Typically used to discharge the timing capacitor in astable/monostable configurations."+ },+ {+ "number": "8",+ "name": "VCC",+ "type": "power_in",+ "description": "Positive supply voltage input. Operating range 1.5V to 15V. Bypass with a 0.1µF ceramic capacitor to GND near the pin."+ }+ ],+ "provenance": {+ "rebuilt": "component block rebuilt 2026-10-05 from this page's own README pinout table and .kicad_sym (pins cross-checked), no re-extraction"+ },+ "viewers": {+ "symbol": "viewers/symbol.html",+ "footprint": "viewers/footprint.html"+ } }-}+}