← Commit history

Initial commit: component/lm3150mhx

Ray ·b625290bd5 ·
2 files changed +88
README.mdadded+54
@@ -0,0 +1,54 @@+# LM3150MHX++**Texas Instruments** · DC-DC Converters · HTSSOP-14-EP++LM3150MHX from Texas Instruments, in a HTSSOP-14-EP. Pinout and pin descriptions extracted from the manufacturer datasheet by ds2sf; symbol, footprint, and 3D from KiCad-official CAD.++## Pinout++| Pin | Name | Type | Function |+|---|---|---|---|+| 1 | VCC | power_out | Internal LDO output supplying the FET gate drivers and internal bias. Nominally regulated to 5.95 V. Connect a 1.0 µF to 4.7 µF decoupling capacitor from this pin to ground. |+| 2 | VIN | power_in | Input supply pin to the device. Nominal input voltage range is 6 V to 42 V (abs max 47 V). |+| 3 | EN | input | Enable input. Apply a logic-high signal greater than 1.26 V (typ) to enable the IC, or leave floating. Ground this pin to disable the controller. Recommended operating range 0 V to 5 V. |+| 4 | FB | input | Feedback input to the regulation, overvoltage, and short-circuit comparators. Regulation setting is 0.6 V. Connect to a feedback resistor divider from the output to set VOUT. |+| 5 | SGND | power_in | Signal ground for all internal bias and reference circuitry. Should be tied to PGND at a single point. Pin 5 and pin 9 are both SGND and must be connected together. |+| 6 | SS | passive | Soft-start capacitor node. An internal 7.7 µA current source charges an external capacitor from this pin to ground to program the output ramp rate at start-up. |+| 7 | RON | input | On-time programming pin. An external resistor from VIN to this pin sets the high-side switch on-time and therefore the switching frequency. |+| 8 | ILIM | input | Current-limit sense input. Monitors the low-side FET current and triggers current-limit operation when the inductor valley current exceeds the threshold set by R_LIM and the 85 µA (typ) I_LIM-TH sense current sourced from this pin. |+| 9 | SGND | power_in | Signal ground (second connection). Tie to PGND at a single point. Must be connected to pin 5. |+| 10 | SW | power_in | Switch node. Connection to the source of the high-side NMOS and drain of the low-side NMOS, and lower supply rail for the high-side gate driver. Boost capacitor (BST) is referenced to this pin. Abs max −3 V to 47 V. |+| 11 | HG | output | High-side NMOS gate drive output. Driver is supplied by the differential voltage between BST and SW (typically ~5.95 V bootstrap rail). |+| 12 | BST | power_in | Bootstrap capacitor connection. Connect a 0.33 µF to 0.47 µF capacitor from SW to this pin. An internal diode charges the cap during the high-side off-time. Do not connect to an external supply rail. Abs max BST-SW 7 V; BST-GND 52 V. |+| 13 | LG | output | Low-side NMOS gate drive output. Driver upper rail is supplied by VCC (~5.95 V). |+| 14 | PGND | power_in | Power ground; source connection for the synchronous low-side MOSFET driver. Tie to the power ground plane and to SGND at a single point. |+| EP | EP | passive | Exposed die-attach thermal pad. Connect directly to SGND and to the PCB ground plane for heat dissipation. |++## Key specifications++| Parameter | Value |+|---|---|+| Manufacturer | Texas Instruments |+| Package | HTSSOP-14-EP |+| Category | PMIC |+| Pins | 15 |++## Ordering variants++- `LM3150MHX`++## CAD (KiCad official)++- Symbol: `LM3150MHX`+- Footprint: `Package_SO:TSSOP-14-1EP_4.4x5mm_P0.65mm`+- 3D model: HTSSOP-14-EP (KiCad packages3D, STEP)++## Provenance++Data extracted from the manufacturer datasheet, not a distributor listing:++- **Datasheet:** [Texas Instruments datasheet](https://www.ti.com/lit/ds/symlink/lm3150mhx.pdf) (32 pp, sha256 `262f4efa528d8294`, retrieved 2026-08-17, tier: manufacturer)+- **Extractor:** `ds2sf` (Claude). Every pin and dimension is cited to a datasheet page; it refuses to fabricate.+- **CAD:** KiCad official libraries (CC-BY-SA 4.0).++[Datasheet PDF](docs/lm3150mhx-datasheet.pdf)
page.jsonadded+34
@@ -0,0 +1,34 @@+{+  "slug": "lm3150mhx",+  "version": "0.1.0",+  "type": "component",+  "description": "Texas Instruments DC-DC Converters, HTSSOP-14-EP. Datasheet-verified pinout, KiCad symbol/footprint/3D.",+  "tags": [+    "component",+    "pmic",+    "lm3150mhx"+  ],+  "dependencies": {},+  "hero": {+    "type": "image",+    "path": "docs/hero.png"+  },+  "files": [+    "page.json",+    "README.md",+    "lm3150mhx.kicad_sym",+    "lm3150mhx.kicad_mod",+    "lm3150mhx.glb",+    "lm3150mhx.step",+    "lm3150mhx.lbr",+    "docs/hero.png",+    "docs/lm3150mhx-datasheet.pdf",+    "viewers/symbol.html",+    "viewers/footprint.html"+  ],+  "visibility": "public",+  "author": {+    "name": "Ray",+    "email": "[email protected]"+  }+}\ No newline at end of file