← Commit history
lm2941mdt: restore the component block (pinout + model declarations) from this page's own README and symbol
1 file changed
+56−1
page.json+56−1@@ -33,5 +33,60 @@ "author": { "name": "Ray", "email": "[email protected]"+ },+ "component": {+ "mpn": "LM2941MDT",+ "manufacturer": "HGSEMI",+ "package": "TO-252-4",+ "pin_count": 5,+ "category": "Voltage Regulators - Linear, Low Drop Out (LDO) Regulators",+ "parts": {+ "symbol": "lm2941mdt.kicad_sym",+ "footprint": "lm2941mdt.kicad_mod",+ "model_3d": "lm2941mdt-etched.glb",+ "model_3d_plain": "lm2941mdt.glb",+ "model_3d_step": "lm2941mdt-etched.step",+ "model_3d_step_plain": "lm2941mdt.step",+ "lbr": "lm2941mdt.lbr"+ },+ "pins": [+ {+ "number": "1",+ "name": "ADJUST",+ "type": "output",+ "description": "Adjust pin. Feedback node for the external resistor divider (R1/R2) that programs the output voltage per VOUT = VREF x (R1+R2)/R1, where VREF is typically 1.275V. Sets output from 5V to 20V."+ },+ {+ "number": "2",+ "name": "ON/OFF",+ "type": "input",+ "description": "TTL/CMOS enable control input. VIN < 0.8V (Von threshold) turns the regulator ON; VIN > 2.0V (Voff threshold) turns it OFF. Input current is typically 50uA (300uA max) at VON/OFF=2.0V. No internal pull; must be externally driven - tie to GND if unused."+ },+ {+ "number": "3",+ "name": "IN",+ "type": "power_in",+ "description": "Unregulated input supply. Recommended operating range up to 26V, absolute maximum 45V. A 470nF (or larger) input bypass capacitor is recommended close to the pin."+ },+ {+ "number": "4",+ "name": "OUT",+ "type": "power_out",+ "description": "Regulated LDO output, 1A capable with typical 0.6V dropout at 1A (1.0V max). Requires a minimum 22uF tantalum output capacitor with ESR between 0.01Ω and 5Ω for loop stability. Internal short-circuit current limit is typically 1.6A."+ },+ {+ "number": "5",+ "name": "GND",+ "type": "power_in",+ "description": "Ground / device reference. On the TO-252-4 package GND is the exposed metal tab on the back of the package (Metal Tab GND); it must be soldered to the board GND plane, which also serves as the primary thermal path (θJA depends on copper area)."+ }+ ],+ "provenance": {+ "rebuilt": "component block rebuilt 2026-10-05 from this page's own README pinout table and .kicad_sym (pins cross-checked), no re-extraction"+ },+ "viewers": {+ "symbol": "viewers/symbol.html",+ "footprint": "viewers/footprint.html"+ } }-}+}