hx24lc04bdbvrg

@@ -33,5 +33,60 @@   "author": {     "name": "Ray",     "email": "[email protected]"+  },+  "component": {+    "mpn": "HX24LC04BDBVRG",+    "manufacturer": "HANSCHIP semiconductor",+    "package": "SOT-23-5",+    "pin_count": 5,+    "category": "EEPROM",+    "parts": {+      "symbol": "hx24lc04bdbvrg.kicad_sym",+      "footprint": "hx24lc04bdbvrg.kicad_mod",+      "model_3d": "hx24lc04bdbvrg-etched.glb",+      "model_3d_plain": "hx24lc04bdbvrg.glb",+      "model_3d_step": "hx24lc04bdbvrg-etched.step",+      "model_3d_step_plain": "hx24lc04bdbvrg.step",+      "lbr": "hx24lc04bdbvrg.lbr"+    },+    "pins": [+      {+        "number": "1",+        "name": "SCL",+        "type": "input",+        "description": "Serial Clock input. Provides the clock reference for the 2-wire I2C-compatible bus (up to 400 kHz Fast mode or 1 MHz High-speed mode). Command/data on SDA is latched on the rising edge of SCL, output data is clocked out on the falling edge. Open-drain bus line requiring an external pull-up to VCC. Schmitt trigger with integrated spike-suppression filter."+      },+      {+        "number": "2",+        "name": "GND",+        "type": "power_in",+        "description": "Ground reference for the power supply. Must be connected to the system ground."+      },+      {+        "number": "3",+        "name": "SDA",+        "type": "bidirectional",+        "description": "Serial Data. Open-drain bidirectional I/O used to serially transfer command, address, and data bytes to/from the device (MSB first). Requires an external pull-up resistor to VCC (see Figure 21 for R_pull vs bus capacitance). Schmitt trigger with integrated spike-suppression filter."+      },+      {+        "number": "4",+        "name": "VCC",+        "type": "power_in",+        "description": "Device power supply, 1.7 V to 5.5 V. Absolute-max -0.5 V to +6.0 V. Typical currents: 0.5 mA read @ 1 MHz, 1 mA write @ 400 kHz, 1 uA standby (max)."+      },+      {+        "number": "5",+        "name": "WP",+        "type": "input",+        "description": "Write Protection input. Tie to VCC to write-protect the entire memory array and Identification Page (device becomes read-only); tie to GND to enable writes. Internally pulled down to GND if left floating. When high, address bytes are ACKed but data bytes are NACKed."+      }+    ],+    "provenance": {+      "rebuilt": "component block rebuilt 2026-10-05 from this page's own README pinout table and .kicad_sym (pins cross-checked), no re-extraction"+    },+    "viewers": {+      "symbol": "viewers/symbol.html",+      "footprint": "viewers/footprint.html"+    }   }-}\ No newline at end of file+}