← Commit history
hx24c08drg: restore the component block (pinout + model declarations) from this page's own README and symbol
1 file changed
+74−1
page.json+74−1@@ -33,5 +33,78 @@ "author": { "name": "Ray", "email": "[email protected]"+ },+ "component": {+ "mpn": "HX24C08DRG",+ "manufacturer": "HANSCHIP semiconductor",+ "package": "SOP-8",+ "pin_count": 8,+ "category": "EEPROM",+ "parts": {+ "symbol": "hx24c08drg.kicad_sym",+ "footprint": "hx24c08drg.kicad_mod",+ "model_3d": "hx24c08drg-etched.glb",+ "model_3d_plain": "hx24c08drg.glb",+ "model_3d_step": "hx24c08drg-etched.step",+ "model_3d_step_plain": "hx24c08drg.step",+ "lbr": "hx24c08drg.lbr"+ },+ "pins": [+ {+ "number": "1",+ "name": "A0",+ "type": "input",+ "description": "Address input. On HX24C08, A0 is a no-connect (device address is decoded only from A2 and internal page bits); the datasheet states it may be tied to GND."+ },+ {+ "number": "2",+ "name": "A1",+ "type": "input",+ "description": "Address input. On HX24C08, A1 is a no-connect (this bit position is repurposed as an internal memory page-address bit); the datasheet states it may be tied to GND."+ },+ {+ "number": "3",+ "name": "A2",+ "type": "input",+ "description": "Hardware device-address input for HX24C08. Must compare to the A2 bit of the I2C device-address byte; allows up to two 8K devices on one bus."+ },+ {+ "number": "4",+ "name": "GND",+ "type": "power_in",+ "description": "Ground reference (0 V) for the device."+ },+ {+ "number": "5",+ "name": "SDA",+ "type": "bidirectional",+ "description": "I2C serial data (bidirectional, open-drain). Requires an external pull-up resistor; may be wire-OR'd with other open-drain devices on the bus."+ },+ {+ "number": "6",+ "name": "SCL",+ "type": "input",+ "description": "I2C serial clock input. Data is clocked into the EEPROM on the positive edge and out on the negative edge. Max 400 kHz at 1.8V/2.5V/2.7V, 1 MHz at 5V."+ },+ {+ "number": "7",+ "name": "WP",+ "type": "input",+ "description": "Write-Protect input. Tie to GND for normal read/write; tie to VCC to hardware-protect the full 8K array against writes."+ },+ {+ "number": "8",+ "name": "VCC",+ "type": "power_in",+ "description": "Supply voltage input, 1.7 V to 5.5 V. Typical ICC = 0.4 mA (read @100 kHz), 2.0 mA (write @100 kHz); standby current ≤ 2 µA."+ }+ ],+ "provenance": {+ "rebuilt": "component block rebuilt 2026-10-05 from this page's own README pinout table and .kicad_sym (pins cross-checked), no re-extraction"+ },+ "viewers": {+ "symbol": "viewers/symbol.html",+ "footprint": "viewers/footprint.html"+ } }-}+}