component
AI01C
Public Made by Adomby adom
Sam wing Touch Sensors, SOT-23-6L. Pinout extracted from the datasheet, KiCad symbol/footprint/3D.
← Commit history
page.json+7−4@@ -32,7 +32,7 @@ "number": "1", "name": "OUT", "type": "output",- "description": "Key-detect output. Behavior is selected by MD: MD=floating gives an open-drain active-low output (requires external pull-up, e.g. 10 k\u03a9); MD=VDD gives push-pull active-high direct output; MD=GND gives a toggle/latch output (each press flips the state). Output sink current up to 10 mA at VCC=5 V; low-level output impedance ~50 \u03a9, high-Z ~100 M\u03a9."+ "description": "Key-detect output. Behavior is selected by MD: MD=floating gives an open-drain active-low output (requires external pull-up, e.g. 10 kΩ); MD=VDD gives push-pull active-high direct output; MD=GND gives a toggle/latch output (each press flips the state). Output sink current up to 10 mA at VCC=5 V; low-level output impedance ~50 Ω, high-Z ~100 MΩ." }, { "number": "2",@@ -44,7 +44,7 @@ "number": "3", "name": "KEY", "type": "input",- "description": "Capacitive touch sense input. Connect to the touch pad/electrode through a series resistor RX (recommended 2 k\u03a9, range 0-5 k\u03a9). An optional CSEL capacitor (0-10 pF) from this pin to GND trims sensitivity; smaller CSEL = higher sensitivity, floating = maximum sensitivity."+ "description": "Capacitive touch sense input. Connect to the touch pad/electrode through a series resistor RX (recommended 2 kΩ, range 0-5 kΩ). An optional CSEL capacitor (0-10 pF) from this pin to GND trims sensitivity; smaller CSEL = higher sensitivity, floating = maximum sensitivity." }, { "number": "4",@@ -56,7 +56,7 @@ "number": "5", "name": "VDD", "type": "power_in",- "description": "Positive supply input, 2.5 V to 6.5 V. Typical Idd \u2248 666 \u00b5A at 5 V, 394 \u00b5A at 3 V (active); ~11 \u00b5A (5 V) / ~7 \u00b5A (3 V) in sleep. A 20 \u03a9 series resistor between the board VDD rail and this pin is recommended (do not omit), and a 100 nF decoupling cap should be placed as close as possible to the pin."+ "description": "Positive supply input, 2.5 V to 6.5 V. Typical Idd ≈ 666 µA at 5 V, 394 µA at 3 V (active); ~11 µA (5 V) / ~7 µA (3 V) in sleep. A 20 Ω series resistor between the board VDD rail and this pin is recommended (do not omit), and a 100 nF decoupling cap should be placed as close as possible to the pin." }, { "number": "6",@@ -126,5 +126,8 @@ "docs/ai01c-datasheet.pdf", "viewers/symbol.html", "viewers/footprint.html"- ]+ ],+ "visibility": {+ "public": true+ } }