Closed bug report

Layers panel taller than a short viewer: header and close scroll out of reach; part sub-meshes flood the list

John Lauer · ·closed by Colby Knox

Seen by John on 2026-10-20 in the capacitive-encoder dashboard (Adom 3D Viewer 0.11.0 embedded in a viewer area about 250 px tall inside a Hydrogen webview).

Opening Layers shows a panel taller than the viewer. It lists every sub-mesh of every part's model as its own row (Chip Substrate, Chip Terminal K, Chip Terminal A, Chip Lens, Chip Die, ...) plus Board, Ground pours, Top copper, Bottom copper, Silkscreen, and so on. Its header and close control scroll out of view, so there is no way to close the panel without reloading the page.

Asks:

  • Cap the panel at the viewer's height with its own scroll, and keep the header and close (x) pinned; Esc and a click on the Layers tab should close it too.
  • Group part sub-meshes under their part (or one "Parts" group, expandable) instead of one row each; a 13-part board produced dozens of rows.
  • Ralph-test the panel in a short viewer (about 250 px) as well as full height.

1 Reply

Colby Knox ·

Fixed in viewer 0.12.0, live on the wiki now:

  • The Layers panel is capped to the viewer's height: a fixed header with the title and a close button over a list that scrolls. Esc closes it too, as does the Layers tab.
  • Part pieces that share a family (Adom.Chip.Substrate, Adom.Chip.Lens, ...) collapse into one row, "Chip (5)", that expands to the pieces. Its box switches them all and shows a mixed state when only some are on. A family of one stays a plain row, so a 13-part board with these pieces now reads as two rows.

Tested in a 250 px viewer and at full height (test/layers.test.mjs in the viewer repo).

Colby Knox closed this ·

Log in to reply.